MONODAQ-E-GMETER MonoDAQ

3-axial MEMS accelerometer with EtherCAT interface and DEWESoft software support. MonoDAQ-E-gMeter A data acquisition device with embedded triaxial MEMS accelerometer, analog-to-digital conversion and EtherCAT interface based on the MonoDAQ EtherCAT platform (www.monodaq.com). Specifications of the MEMS accelerometer: Min. Typ. Max. Unit Measurement ranges +-2 +-8 g -3 dB bandwidth 1000 Hz Noise density (+-2 g) 25 ug Hz Offser error -75 +-25 +75 mg Offset temp. drift (-40...125 degC) -0.15 +-0.02 0.15 mg/C Sensitivity temp. drift (-40...125 degC) +-0.01 %/degC Linearity error -1g ... +1g range 0.1 % FS Crossaxis sensitivity -1 +1 % Specifications of the MonoDAQ-E-gMeter device: Digital interface EtherCAT Interface connectors RJ45 Power consumption 1300 mW Supply voltage 12-48 V Operating temperature -20 ... 60 degC IP rating IP20 Software support: DEWESoft X3, any standard EtherCAT master Installation: Devices are daisy chained with a standard network cable. It is recommended that the cable is shielded (SFTP, CAT5e) and has a minimum 24 AWG wire thickness. The cable must have 4 wire pairs. The maximum distance node-to-node is 50 m. Power supply: Passive PoE power injector is neccessary for merging the EtherCAT signal and power into a single cable. Max. number of devices from a single power Power supply voltage Cable length device-to-device Cable size supply 24 V 1 m AWG 24 8 24 V 50 m AWG 24 4 48 V 1 m AWG 24 12 48 V 50 m AWG 24 10 Contact for details and pricing. Version 2.0 X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Acceleration Sensor Modules category: Click to view products by MonoDAQ manufacturer: Other Similar products are found below : SCA10H-D01-112 SCA11H-G01-036