Instruction Sheet SMA* Hermetically-Sealed 408-4847 Panel Feedthrough Jack Receptacles 31 OCT 11 Rev B Jack Metal Gasket Recommended Panel Cutout Note: Dimensions are in inches over millimeters. Figure 1 1. INTRODUCTION SMA Hermetically-Sealed Panel Feedthrough Jack Receptacles 1053159-1, 1053181-1, 1053182-1, 1053226-1, 1053227-1, 1053254-1, 1061372-1, and 1089139-1 are designed to be mounted onto a panel using the following tools: PART NUMBER CROSS-REFERENCE TOOL DESCRIPTION TE CONNECTIVITY M/A-COM Step Reamer 1055284-1 2098-0442-54 .250-36, UNS-2B - - 2098-5618-54 Bottoming Tap Torque Tool 1055251-1 2098-0248-54 - - - - Figure 2 3/8-in. Open Wrench Commercially available Unless otherwise specified, dimensions in this NOTE Torque Tool instruction sheet are in metric units with U.S. Detail A customary units in brackets . i Turn Handle Clockwise Reasons for reissue of this instruction sheet are provided in Section 5, REVISION SUMMARY. 2. DESCRIPTION Collet (Ref) The jack receptacle consists of a jack and metal Detail B gasket. See Figure 1. Jack 3. ASSEMBLY PROCEDURE Follow safety precautions included with the tools DANGER used for assembly. STOP Figure 3 1. Refer to Figure 2, and drill a hole in the panel to 3. Install the metal gasket onto the jack. See the diameter shown. Using the step reamer, ream Figure 4. the hole to the depth shown. Using the bottoming tap, tap the thread to the depth shown. Metal Gasket 2. While holding the collet of the torque tool, turn the handle clockwise until it stops. Thread the jack into the tool until it bottoms inside the tool. Hand-tighten the jack. Refer to Figure 3. The torque tool is preset between 2.60 and 3.05 NOTE Nm 23 and 27 in.-lb . Figure 4 i 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change. 1 of 2 All Rights Reserved PRODUCT INFORMATION 1-800-522-6752 For latest revision and Regional Customer Service, *Trademark visit our website at www.te.com LOC B TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. 408-4847 4. Thread the jack into the connector housing by 4. REPLACEMENT AND REPAIR turning the handle of the torque tool clockwise until Discard and replace any defective or damaged jack the handle releases. See Figure 5, Detail A. receptacles or metal gaskets. 5. While holding the collet of the torque tool with the open wrench, turn the handle counter- clockwise, 5. REVISION SUMMARY and remove the jack assembly from the torque tool. Since the previous version of this document, the See Figure 5, Detail B. following changes were made: 6. Install the jack assembly onto the panel. Updated document to corporate requirements. Connector Housing Handle of Torque Tool Detail A Turn Handle Clockwise Collet (Ref) Detail B Turn Handle Counterclockwise Figure 5 Rev B 2 of 2