DC-HVDC Converter F Series 10 Watts Output Voltages from 100V to 12kV 2xxx 2ries Output Voltage Proportional to Input Low Turn-on Voltage 0.7VDC Input to Output Isolation Dual Output Option Arc & Short Circuit Protected No Minimum Load 3 Year Warranty Dimensions: The F Series is a broad line of robust, field-proven DC to HV DC converters which F Series: deliver 10 Watts continuous output power. Outputs range from 100V to 12kV. 2.80 x 1.70 x 0.85 (71.1 x 43.2 x 21.6mm) The input and output are galvanically isolated so a unit can be used to deliver a positive or negative high voltage output. The output voltage is proportional to input voltage with a low 0.7V typical turn-on voltage. Key Applications: The F Series employs a quasi-sinewave oscillator, a fully enclosed transformer, Mass Spectrometry input and output filtering, and a 5-sided metal enclosure. As a result, these Electrostatic Chucks Electrophoresis modules exhibit very low EMI/RFI, noise and ripple. A dual output option has Capacitor Charging a center-tap pin which, when grounded provides both positive and negative Particle Counter outputs from one compact module. Isolation Testing Medical Laser Treatment Input Characteristic Minimum Typical Maximum Units Notes & Conditions Input Voltage 0.7 12, 15 VDC See Models and Ratings Table. Input Current, No Load 500 mA Input Current, Full Load 1.5 A Output Characteristic Minimum Typical Maximum Units Notes & Conditions Output Voltage 12,000 VDC See Models and Ratings Table Output Current 100 mA See Models and Ratings Table Output Voltage Tolerance +5, -5 % At Max Vout, Full Load Minimum Load No minimum load required Regulation Unregulated, Output is proportional to Input. See Application Notes. Short Circuit Protection Protected against short circuit conditions indefinitely. Ripple and Noise 0.1 2.5 % See Models and Ratings Table. Response Time 260 msec 0 to Max Vout, Full Load Notes 1. Maximum rated output current is available at maximum rated output voltage and 4. Proper thermal management techniques are required to maintain safe case derates linearly as input voltage is decreased. temperature at maximum power output. 2. Output voltage is load dependent. Under light or no-load conditions, reduce the 5. Ripple specification for center-tapped units applies to the voltage between the input voltage so maximum rated output voltage is not exceeded. positive and negative output terminals. 3. Specifications after 1 hour warm-up, full load, at 25C unless otherwise indicated. www.xppower.com 1DC-HVDC Converter F Series Environmental Characteristic Minimum Typical Maximum Units Notes & Conditions Operating Temperature (case) -10 +70 C Standard operating temperature Storage Temperature -25 +90 C Humidity 95 %RH Non-condensing Cooling Natural Convection General Characteristic Minimum Typical Maximum Units Notes & Conditions Isolation: Input to Output 3,500 V < 3,500 Bias for Models F01 to F60 Isolation: Input to Output 500 V < 500 Bias for Models F70 to F121 Switching Frequency 25 125 kHz Stable frequency over entire output voltage range. Construction Case material is black anodized aluminum. UL 94 V-0 rated solid vacuum encapsulation. Mean Time Between Failure 810 kHrs Bellcore TR 332 Block Diagram 1 3 (+) In (+) Output Rectifier & Oscillator Multiplier 5 Center tap (for Dual output option) 2 4 (-) In (-) Output Transformer Case Temperature Hot Spot HOT SPOT CASE TEMPERATURE POINT 2.80 (71.12) 1.70 (43.18) www.xppower.com 2