SE60N3x Surface-Mount Standard Rectifiers are AEC-Q101 qualified, ideal for automated replacement, and offer ESD capability. These rectifiers provide leadless DFN packages with side-wettable flanks suitable for customer Automatic Optical Inspection (AOI). The SE60N3x surface mount standard rectifiers have a single configuration and SMD/SMT mounting style. These rectifiers feature a low-profile package with a typical height of 0.88mm. The SE60N3x rectifiers operate at -55°C to 175°C junction tem..
View Products

PTC Thermistors, Inrush Current Limiter High Energy. These directly heated ceramic-based doped barium titanate thermistors have a positive temperature coefficient and are primarily intended for inrush current limiting and overload protection.
FEATURES
Higher energy absorption levels up to 300 J
High number of inrush-power cycles:> 100 000 cycles
Highly resistant against non-switching peak-powers of up to 25 kW
Can handle high direct voltage up to 1200 V
View Products

Power Metal Strip Resistors, High Power (2 x Standard WSL),Low Value (Down to 0.0005 Ohm), Surface-Mount
FEATURES
All welded construction of the Power Metal Strip resistors are ideal for all types of current sensing, voltage division and pulse applications
Proprietary processing technique produces extremely low resistance values (down to 0.0005 Ohm)
Sulfur resistance by construction that is unaffected by high sulfur environments
Very low inductance 0.5 nH t..
View Products

The P16S is a revolutionary concept in panel mounted potentiometers. This unique design consists of a knob driving and incorporating a cermet potentiometer. Only the mounting hardware and terminals are situated on the back side of the panel reducing to a minimum the required clearance.
FEATURES
P16S - version for military, professional and
industrial applications (cermet): 1 W at 40 °C
PA16S - version for professional audio
applications (conductive plastic)..
View Products

Power Resistor for Mounting onto a Heatsink Thick Film Technology RECOMMENDATIONS FOR MOUNTING ONTO A HEATSINK
Surfaces in contact must be carefully cleaned.
The heatsink must have an acceptable flatness: From 0.05 mm to 0.1 mm/100 mm.
Roughness of the heatsink must be around 6.3 µm. In order to improve thermal conductivity, surfaces in contact (alumina,heatsink) should be coated with a silicone grease (type Bluesil Past 340 from BlueStar Silicones) or a thermal film (..
View Products