Temflex 2155 Rubber Splicing Tape Data Sheet Product Description Specification 3M Temflex 2155 Rubber Splicing Tape is a conformable The tape must be rubber based and capable of operating at self-fusing rubber electrical insulating tape. It is designed for temperatures up to 80C. low voltage electrical insulating and moisture sealing The tape must not split or crack when exposed to normal applications. Temflex 2155 is Underwriters Laboratories operating temperatures. The tape must be compatible with (UL) Listed for use up to 600 volts. synthetic cable and wire insulations. The tape shall not be UL listed, File E129200 corrosive to aluminum, or copper conductors. Compatible with solid dielectric cable insulations The tape shall be 30 mils thick and comply with the Self-fusing tape requirements of UL 510 for rubber insulating tape. Flexible over a wide temperature range Installation Applications (600 volt maximum) Temflex 2155 tape should be applied in half-lapped layers Bolted connections until desired insulation build up is reached. Stretch the tape Service drops to 3/4 of its original width during application for good Lightning connections conformability and to obtain a moisture tight seal. Ground rod connections Motor leads Temflex 2155 tape should be overwrapped for mechanical protection with half-tapped layers of either 3M Vinyl Electrical Tape or Temflex 1755 Cotton Friction Tape. Typical Data/Physical Properties Test Method Typical Value Shelf Life Color Black Temflex 2155 has a three-year shelf life (from date of Temperature Rating manufacture) when stored under the following recommended UL 510 176F (80C) storage conditions. Store behind present stock in a clean, dry Thickness place at a temperature of 70F (21C) and 40-50% relative UL 510 30 mils (0,76 mm) humidity. Good stock rotation is recommended. Fusion ASTM D4388, Type I Pass Availability Tensile Strength Temflex 2155 rubber splicing tape is available from your 2 UL 510 300 psi (2,07 N/mm ) local 3M authorized distributor in the following roll sizes: Elongation 3/4 in. x 22 ft. (19 mm x 6,7 m) UL 510 700% 1 1/2 in. x 22 ft. (38 mm x 6,7 m) Dielectric Breakdown UL 510 600 V/mil (23,6 KV/mm) Note: These are typical values and should not be used for specification purposes.3M and Temflex are trademarks of 3M. IMPORTANT NOTICE All statements, technical information, and recommendations related to 3Ms products are based on information believed to be reliable, but the accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability associated with such use. Any statements related to the product which are not contained in 3Ms current publications, or any contrary statements contained on your purchase order shall have no force or effect unless expressly agreed upon, in writing, by an authorized officer of 3M. Warranty Limited Remedy Limited Liability. This product will be free from defects in material and manufacture for a period of 3 years from the date of manufacture. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the shelf life period stated above, your exclusive remedy shall be, at 3Ms option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be liable for any loss or damage arising from this 3M product, whether direct, indirect, special, incidental or consequential regardless of the legal theory asserted. Electrical Products Division 6801 River Place Blvd. Austin, TX 78726-9000 800/245-3573 Printed on 50% recycled paper Litho in USA www.3M.com/elpd with 10% post-consumer 3M 1999 78-8124-5364-1-A