3442-39N 3M

3M Locator Plate 3443-112 3M Platens 3442-44, 3442-9 Instructions for the assembly of 3M D Sub Connectors 8250 and 8350 1.0 General 3M manual and pneumatic assembly presses and accessory assembly equipment are recommended for the termination of 3M D Sub Connectors. 3M assembly equipment is offered to help reduce set-up time, to provide easier and faster assembly and to help reduce assembly error. The 3M Locator Plate 3443-112 and 3M Platen 3442-44 were designed to assemble the D Sub Connector 8250. The Locator Plate 3443-112 is used with the 3M Platen 3442-9 to assemble the D Sub Connector 8350. 3436-1F Shut Height Setting Connector Part Locator Plate Number Platen Part Number Assembly Press Assembly Presses Assembly Presses Number 3640/3316 3335/3339-1 8250 *3443-112 3442-44 15 15 1/2 3830 8350 *3443-112 3442-9 20 20 1/2 3830 *Included with the Locator Plate 3443-112 is a Platen 3442-44. The Platen 3442-44 can also be purchased separately. March 2013 78-9101-0518-4-B 2.0 Procedures for Set Up: 2.1 Adjust the shut height setting (see Figures 2 through 4). Platen 3442-44 Adjustment (3442-9 not shown) Shaft Mount Platen to Locator Plate Platen Clip Alignment Guides End Guide Assembly Pocket Locator Plate 3443-112 Assembly Press Base Mounting Holes (4 places) 3M cable types can be assembled to either connector with the Locator Plate 3443-112. Figure 1: 3M Locator Plate 3443-112 3.0 Procedures for Adjusting Shut Height 3.1 The shut height should be adjusted from the base before the locator plate is put into place. The 3M Assembly Presses 3316 and 3640 are adjusted with a knob at the top of the press. The 3M Assembly Press 3335 is adjusted with the collar on the press shaft, and the 3M Assembly Press 3830 is self- adjusting. 3.2 The shut height adjustment is made from the base of the assembly press without the locator plate or platen in place. 3.3 Place the shut height gauge across the assembly press base. (See Figures 2 and 3) Figure 2: Shut Height Adjustment 3.4 Lower the handle of the assembly press until the handle casting makes contact with the press casting. 3.5 Rotate the shut height to lower or raise adjustment feature until the bottom of the shaft contacts the desired position on the shut height gauge. (See Figures 3 and 4) Figure 3: 3M Assembly Press 3640 2