3640 3M

Pak 50E and 50 Assembly Application Tools Instructions The assembly of 3M PAK 50E connectors and 3M 3365 Cable can be accomplished when using the 3M 3443-128 Series Locator Plate and the 3M 3640 or 3335 Assembly Press. Tools required: Product Description Stock Number 3e443-128L9ocator Plat 80-4000-1626- 3s640A8ssembly Pres 80-6100-7882- 3s335A)ssembly Pres 80-6100-3208-0 (alternate to the 3640 3e436-1JS2hut Height Gag 78-8118-0908- 3n442-126 P2late 80-6104-7838- PAK 50E Connector PAK 50E Cover 2 Cover 1 Assembly Press Setup 1. The 3M 3436-1J Shut Height Gauge was shipped with the locator plate. The setting height is inscribed on the side of the gauge. The setting of 18 1/2 is for the 3M 3640 Press and the setting of 19 is for the 3M 3335 Press. Shut height 2. Place the shut height gauge on the base of the gage press and bring down the shaft of the press onto 3436-1J the surface of the shut height gauge lightly. Adjust the shaft length by turning the adjusting knob on the top of the shaft (3640) or the adjusting collar on the lower portion of the shaft of the press (3335) so that the press handle comes completely down with only a small amount of pressure from the press shaft on the shut height 3771 Base Plate gauge. On the 3335 only, tighten the locking collar. The shut height distance is now set. Assembly Press Setup 3. Place the 3M 3442-126 Platen on the end of the press shaft and lock it in place by sliding the holding clamp on the platen into the groove on the press shaft. Your assembly press is now setup. Note: The 3640 in the picture is shown with the separately purchased 3M 3771 Base Plate which adds stabilization to the press. Its use is optional. The 3335 Heavy Duty press is also applicable, but not shown. Locator Plate Setup 1. The 3M PAK 50 Connector may only be terminated to the end of two cables. It may not be daisy-chained. Base Cover 2. Place the cable stops into the holes in the locator plate. 3. Using a piece of cable, adjust the cable guide so that the cable will be positioned in the center of the locator plate when the edge of the cable is against the guide. The small ridges on the surface Cable Stop of the locator plate will help to hold the cable straight and in position for termination. Cable guide 4. The locator plate can now be positioned on the Cable Placement press base under the platen. Some operators prefer to place the locator plate into the press after they have prepped the cable and connector Locator Plate Setup for termination. If you prefer this method, be sure that the cable and connector do not move when you place the locator plate into place on the press. 78-8133-3511-0-A 2