3829-01 3M

MDR Hand Tool Kit 3829 Instructions for the assembly of 3M Plug Connector 101XX-6000XX Series onto 3M Round Jacketed Discrete Wire Cable 3600 or 3644 Series. All items shown below are included in the basic unit of the 3M MDR Hand Tool Kit 3829, stock number FE-5100-0088-1. 3M Replacement Blades 3828 3M Cover Stops P/N FE-5100-1155-7 3M Hand Press 3829 3M Cutting Unit 3829-05 P/N FE-5100-3869-1 3M Platen 3829-04 P/N FE-5100-3868-3 3M Fixture Unit 3829-02 P/N FE-5100-3866-7 3M Bench Clamp 3829-01 3M Locator Plate 3829-03 P/N FE-5100-3865-9 P/N FE-5100-3867-5 Hex Key 3M Gauge Block 3M MDR Plug Connector 101XX-6000XX Slotted Cover Connector Body nd 2 Cover 3M MDR Hand Tool 3829 set-up Mounting area for 3M Cutting Unit 3829-05 and 3M Platen 3829-04. Mount the 3M Hand Press to a bench using the 3M Bench Clamp. Mounting area for 3M Fixture Unit 3829-02 and 3M Locator Plate 3829-03. Cover set-up and installation Place correct cover stop here. Number on the cover stop indicates the correct connector size. 3M Fixture Unit 3829-02 To install the slotted cover: A. Close cover locks. Adjustment knob B. Check that slotted cover is forward. for cable location C. Place and push cover against cover stop. on 3M Fixture D. Push cover down and behind the cover lock. Unit 3829-02. Slide cover lock in to close and locate th e co ve r position. Backshells -- remember to put them on. Cable and Connector Termination Step One Cable preparation expose approximately three inches of cable. Position wires in cover slot by spreading individual wires into color groups as directed by your wiring diagram. Position 3M Fixture Unit 3829-02 in 3M Hand Press 3829. Hold the cable in the cable clamp by tightening this knob. Place cable into the clamp to start the assembly process.