Data Sheet GE TM 6A Digital SlimLynx Open Frame: Non-Isolated DC-DC Power Modules 3Vdc 14.4Vdc input 0.45Vdc to 5.5Vdc output 6A Output Current Features Ultra low height design for very dense power applications. Small size: 20.32 mm x 11.43 mm x 2.8 mm (Max) (0.8 in x 0.45 in x 0.11 in) Output voltage programmable from 0.6Vdc to 5.5Vdc via external resistor. Digitally adjustable down to 0.45Vdc Wide Input voltage range (3Vdc-14.4Vdc) Wide operating temperature range -40C to 105C . See RoHS Compliant derating curves DOSA approved footprint TM Digital interface through the PMBus protocol TM Tunable Loop to optimize dynamic output voltage response Applications Flexible output voltage sequencing EZ-SEQUENCE Distributed power architectures Power Good signal Intermediate bus voltage applications Remote On/Off Telecommunications equipment Fixed switching frequency with capability of external synchronization Servers and storage applications Output overcurrent protection (non-latching) Networking equipment Ability to sink and source current Industrial equipment Compatible in a Pb-free or SnPb reflow environment Vin+ Vout+ UL* 60950-1Recognized, CSA C22.2 No. 60950-1-03 VIN VOUT VS+ Certified, and VDE 0805:2001-12 (EN60950-1) Licensed PGOOD RTUNE MODULE Compliant to RoHS II EU Directive 2011/65/EU SEQ CTUNE Compliant to REACH Directive (EC) No 1907/2006 CLK Cin TRIM Co DATA Compliant to IPC-9592 (September 2008), Category 2, ADDR0 SMBALRT Class II RTrim ADDR1 ISO** 9001 and ISO 14001 certified manufacturing ON/OFF RADDR1 RADDR0 facilities SIG GND SYNC GND VS- GND Description TM The 6A Digital SlimLynx Open Frame power modules are non-isolated dc-dc converters that can deliver up to 6A of output current. These modules operate over a wide range of input voltage (V = 3Vdc-14.4Vdc) and provide a precisely regulated output IN voltage from 0.45Vdc to 5.5Vdc, programmable via an external resistor and PMBus control. Features include a digital interface using the PMBus protocol, remote On/Off, adjustable output voltage, over current and over temperature protection in the controller. The PMBus interface supports a range of commands to both control and monitor the module. The module also includes TM the Tunable Loop feature that allows the user to optimize the dynamic response of the converter to match the load with reduced amount of output capacitance leading to savings on cost and PWB area. * UL is a registered trademark of Underwriters Laboratories, Inc. CSA is a registered trademark of Canadian Standards Association. VDE is a trademark of Verband Deutscher Elektrotechniker e.V. ** ISO is a registered trademark of the International Organization of Standards The PMBus name and logo are registered trademarks of the System Management Interface Forum (SMIF) June 15, 2016 2016 General Electric Corporation. All rights reserved. GE Data Sheet TM 6A Digital SlimLynx Open Frame: Non-Isolated DC-DC Power Modules 3Vdc 14.4Vdc input 0.45Vdc to 5.5Vdc output 6A Output Current Absolute Maximum Ratings Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings only, functional operation of the device is not implied at these or any other conditions in excess of those given in the operations sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect the device reliability. Parameter Device Symbol Min Max Unit Input Voltage All V -0.3 15 V IN Continuous SEQ, SYNC, VS+ All 7 V CLK, DATA, SMBALERT All 3.6 V Operating Ambient Temperature All T -40 105 C A (see Thermal Considerations section) Storage Temperature All T -55 125 C stg Electrical Specifications Unless otherwise indicated, specifications apply over all operating input voltage, resistive load, and temperature conditions. Parameter Device Symbol Min Typ Max Unit Operating Input Voltage All V 3 14.4 Vdc IN Maximum Input Current All I 6 Adc IN,max (V =3V to 14V, I =I ) IN O O, max V = 0.6 Vdc I 31.3 mA O,set IN,No load Input No Load Current (VIN = 12Vdc, IO = 0, module enabled) V = 5Vdc I 178.7 mA O,set IN,No load Input Stand-by Current All IIN,stand-by 11 mA (V = 12Vdc, module disabled) IN 2 2 Inrush Transient All I t 1 A s Input Reflected Ripple Current, peak-to-peak (5Hz to 20MHz, 1H source impedance VIN =0 to All 37.6 mAp-p 14V, IO= IOmax See Test Configurations) Input Ripple Rejection (120Hz) All -55 dB June 15, 2016 2016 General Electric Corporation. All rights reserved. Page 2