Data Sheet GE TM 6A Analog SlimLynx Open Frame: Non-Isolated DC-DC Power Modules 3Vdc 14.4Vdc input 0.6Vdc to 5.5Vdc output 6A Output Current Features Ultra low height design for very dense power applications. Small size: 20.32 mm x 11.43 mm x 2.8 mm (Max) (0.8 in x 0.45 in x 0.11 in) Output voltage programmable from 0.6Vdc to 5.5Vdc via external resistor. Wide Input voltage range (3Vdc-14.4Vdc) Wide operating temperature range -40C to 105C . See derating curves RoHS Compliant DOSA approved footprint TM Tunable Loop to optimize dynamic output voltage response Flexible output voltage sequencing EZ-SEQUENCE Power Good signal Applications Remote On/Off Distributed power architectures Fixed switching frequency with capability of external Intermediate bus voltage applications synchronization Telecommunications equipment Output overcurrent protection (non-latching) Servers and storage applications Ability to sink and source current Compatible in a Pb-free or SnPb reflow environment Networking equipment UL* 60950-1Recognized, CSA C22.2 No. 60950-1-03 Industrial equipment Certified, and VDE 0805:2001-12 (EN60950-1) Licensed Vin+ Vout+ VIN VOUT Compliant to RoHS II EU Directive 2011/65/EU VS+ PGOOD Compliant to REACH Directive (EC) No 1907/2006 RTUNE MODULE Compliant to IPC-9592 (September 2008), Category 2, SEQ CTUNE Class II Cin TRIM Co ISO** 9001 and ISO 14001 certified manufacturing facilities RTrim ON/OFF SIG GND SYNC GND VS- GND Description TM The 6A Analog SlimLynx Open Frame power modules are non-isolated dc-dc converters that can deliver up to 6A of output current. These modules operate over a wide range of input voltage (VIN = 3Vdc - 14.4Vdc) and provide a precisely regulated output voltage from 0.6Vdc to 5.5Vdc, programmable via an external resistor. Features include remote On/Off, adjustable output voltage, TM over current and over temperature protection in the controller. The module also includes the Tunable Loop feature that allows the user to optimize the dynamic response of the converter to match the load with reduced amount of output capacitance leading to savings on cost and PWB area. * UL is a registered trademark of Underwriters Laboratories, Inc. CSA is a registered trademark of Canadian Standards Association. VDE is a trademark of Verband Deutscher Elektrotechniker e.V. ** ISO is a registered trademark of the International Organization of Standards September 24, 2014 2014 General Electric Corporation. All rights reserved. Data Sheet GE TM 6A Analog SlimLynx Open Frame: Non-Isolated DC-DC Power Modules 3Vdc 14.4Vdc input 0.6Vdc to 5.5Vdc output 6A Output Current Absolute Maximum Ratings Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings only, functional operation of the device is not implied at these or any other conditions in excess of those given in the operations sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect the device reliability. Parameter Device Symbol Min Max Unit Input Voltage All VIN -0.3 15 V Continuous SEQ, SYNC, VS+ All 7 V Operating Ambient Temperature All T -40 105 C A (see Thermal Considerations section) Storage Temperature All Tstg -55 125 C Electrical Specifications Unless otherwise indicated, specifications apply over all operating input voltage, resistive load, and temperature conditions. Parameter Device Symbol Min Typ Max Unit Operating Input Voltage All VIN 3 14.4 Vdc Maximum Input Current All IIN,max 6 Adc (VIN=3V to 14V, IO=IO, max ) VO,set = 0.6 Vdc IIN,No load 31.3 mA Input No Load Current (VIN = 12Vdc, IO = 0, module enabled) VO,set = 5Vdc IIN,No load 178.7 mA Input Stand-by Current All I 11 mA IN,stand-by (VIN = 12Vdc, module disabled) 2 2 Inrush Transient All It 1 A s Input Reflected Ripple Current, peak-to-peak (5Hz to 20MHz, 1 H source impedance V =0 to All 37.6 mAp-p IN 14V I = I See Test Configurations) , O Omax Input Ripple Rejection (120Hz) All -55 dB September 24, 2014 2014 General Electric Corporation. All rights reserved. Page 2