EA1216FA08-40.000M TR
(Data Sheet downloaded on Aug 17, 2020)
REGULATORY COMPLIANCE
2011/65 +
191 SVHC
2015/863
ITEM DESCRIPTION
Quartz Crystal Resonator 1.2mm x 1.6mm x 0.4mm 4 Pad Ceramic Surface Mount (SMD) 40.000MHz 30ppm at 25C, 50ppm
over -40C to +85C 08pF Parallel Resonant
ELECTRICAL SPECIFICATIONS
Nominal Frequency 40.000MHz
Frequency Tolerance/Stability 30ppm at 25C, 50ppm over -40C to +85C
Aging at 25C 3ppm/year Maximum
Load Capacitance 08pF Parallel Resonant
Shunt Capacitance 3.5pF Maximum
Equivalent Series Resistance 150 Ohms Maximum
Mode of Operation AT-Cut Fundamental
Drive Level 100Watts Maximum
Spurious Response -3dB Minimum (Measured from Fo to Fo +5000ppm)
Storage Temperature Range -40C to +125C
Insulation Resistance 500 Megaohms Minimum (Measured at 100Vdc)
ENVIRONMENTAL & MECHANICAL SPECIFICATIONS
ESD Susceptibility MIL-STD-883, Method 3015, Class 1, HBM: 1500V
Fine Leak Test MIL-STD-883, Method 1014, Condition A
Flammability UL94-V0
Gross Leak Test MIL-STD-883, Method 1014, Condition C
Mechanical Shock MIL-STD-883, Method 2002, Condition B
Moisture Resistance MIL-STD-883, Method 1004
Moisture Sensitivity J-STD-020, MSL 1
Resistance to Soldering Heat MIL-STD-202, Method 210, Condition K
Resistance to Solvents MIL-STD-202, Method 215
Solderability MIL-STD-883, Method 2003
Temperature Cycling MIL-STD-883, Method 1010, Condition B
Vibration MIL-STD-883, Method 2007, Condition A
www.ecliptek.com | Specification Subject to Change Without Notice | Revision A 08/29/2017 | Page 1 of 5
Ecliptek, LLC 5458 Louie Lane, Reno, NV 89511 1-800-ECLIPTEK or 714.433.1200MARKING
ORIENTATION
EA1216FA08-40.000M TR
MECHANICAL DIMENSIONS (all dimensions in millimeters)
PIN CONNECTION
1 Crystal
1.20
0.30 0.10
0.10
2 Cover/Ground
(X2)
3 Crystal
1
4 4 No Connect
LINE MARKING
1.60
0.10
1 XXXXX
XXXXX=Ecliptek
Manufacturing Identifier
0.50
3 2
0.10 (X2)
0.40 MAX
Note: Chamfer not shown.
Seam Sealed
Terminal Plating Thickness: Gold (0.3 to 1.0m) over Nickel (2.00 to 8.89m).
Suggested Solder Pad Layout
All Dimensions in Millimeters
0.60 (X4)
0.75 (X4)
Solder Land
0.30
(X4)
0.20
All Tolerances are 0.1
www.ecliptek.com | Specification Subject to Change Without Notice | Revision A 08/29/2017 | Page 2 of 5
Ecliptek, LLC 5458 Louie Lane, Reno, NV 89511 1-800-ECLIPTEK or 714.433.1200