5.0x3.2mm LVDS Oscillator O5LS DATASHEET (Former F540D, F530D series) LVDS Output Stabilities to 20 PPM Temperature Ranges as wide as 40C to +85C Supply Voltages: 2.5V, 3.3V Specifications PARAMETERS MAX (unless otherwise noted) Frequency Range 25.000 ~ 170.000 MHz Storage Temperature Range (T ) -55 ~ +125C STG Supply Voltage (V ) 2.5V10%, 3.3V10% DD Input Current (I ) 50 mA DD Standby Current 15 uA Output Symmetry (50% V ) 45% ~ 55% P-P Rise Time (20%~80% V ) 0.5 nS P-P Fall Time (80%~20% V ) 0.5 nS P-P Differential Output Voltage (V ) 0.247V ~ 0.454V OD Differential Offset Voltage (V ) 1 .12 5V ~ 1.375V OS Output Load 100 Ohms Typical Start-up Time (T ) 10 mS S 1 Output Disable Time 200 nS 1 Output Enable Time 10 mS Aging (per year 25C) 3 PPM Phase Jitter (12kHz~20MHz) 0.5 pS Maximum Soldering Temp / Time 260C / 10 Seconds Moisture Sensitivity Level (MSL) 1 Termination Finish Au over Ni Seal Method Seam Seal Lead (Pb) Free Yes ROHS/REACH Compliant Yes ENABLE / DISABLE FUNCTION Pin1 Out 1 (pin 4), Out 2 (pin 5) 1 OPEN Active Active 1 Level V 70%V IH DD 0 Level V 30%V High Z IL DD 2 Available Options by Stability & Operating Temp Frequency Operating Frequency Range (MHz) 2 Stability Temperature (C) 100PPM 25.000 ~ 170.000 -20 ~ +70 Dimensions are in millimeters. 100PPM -40 ~ +85 25.000 ~ 170.000 50PPM -20 ~ +70 25.000 ~ 170.000 Pin Connections -40 ~ +85 25.000 ~ 170.000 50PPM 25PPM -20 ~ +70 25.000 ~ 170.000 4 Output 1 1 E/D -40 ~ +85 25.000 ~ 170.000 25PPM 2 NC 5 Output 2 20PPM -20 ~ +70 25.000 ~ 170.000 3 GND 6 V DD 1 An internal pull-up resistor from pin 1 to pin 6 allows active output if pin 1 is left open. 2 Inclusive of 25 C tolerance, and operating temperature range. Notes: A 0.01F capacitor should be placed between V (Pin 6) and GND (Pin3) to minimize power supply line noise. DD Dimensional drawing is for reference to critical specifications defined by size measurements. Certain non-critical visual attributes, such as side castellations, reference pin shape, etc. may vary Title / Description: O5LS SERIES STANDARD SPECIFICATIONS Reference / Comments Drawing Number: 101137 Size: A Part Number: Cage: 61429 Draftsperson: CMR Approved: BEC Date: 08/21/2017 Copyright 2017 Fox Electronics, All rights reserved Page 1 of 3 5.0x3.2mm LVDS Oscillator O5LS DATASHEET (Former F540D, F530D series) RECOMMENDED CIRCUIT WAVEFORM CHARACTERISTICS TAPE/REEL SPECIFICATIONS Tape Specifications (millimeters) Reel Specifications (millimeters) A B C D E F Std Reel Qty G H I J K L M 1.5 4.0 8.0 5.5 12.0 1.5 1,000 2.0 13 21 62 180 13.5 2.0 Title / Description: O5LS SERIES STANDARD SPECIFICATIONS Reference / Comments Drawing Number: 101137 Size: A Part Number: Cage: 61429 Draftsperson: CMR Approved: BEC Date: 08/21/2017 Copyright 2017 Fox Electronics, All rights reserved Page 2 of 3