T0510-001 Access Communications

Product Specification sheet 05G Series Plug-in Switch Mode Power Supply Unit INPUT MINIMUM NORMAL MAXIMUM AC Input Voltage 90V AC 100 240V AC 264V AC AC Input Frequency 47 Hz 50 / 60 Hz 63 Hz AC Input Current 230V AC (max) 0.15A Input Power (max) 8.3W AC Inrush Current* 230V AC, 50Hz No immediate damage or long term impact. Peak inrush current is limited to 60A for a cold start. Primary current protection An internal fuse on the AC input line is provided. Configuration Wall mount, AU-pin, 2-conductors, <Active, Neutral> Power consumption at no load Input current 15mA Input 230V AC 50 Hz 0.5W max OUTPUT MODEL 5V DC 6V DC 9V DC 12V DC Normal DC Output Voltage +5V +6V +9V +12.0V Maximum Load Current 1.00A 0.83A 0.55A 0.42A Minimum Load Current 0.05A 0.05A 0.05A 0.05A Rated Output Power 5.00W 5.00W 5.00W 5.00W Load Regulation 5% from 10% to 100% of rated load Ripple and Noise * 100mV Over-current Protection Adaptor protected with 200% of rated output. Over-voltage Protection Zener clamp. 9V maximum. Short-circuit Protection The adaptor shall not be damaged by shorting the DC output to Ground with auto recovery functioning correctly. Hold-up Time (min) ** 10mS Output over-shoot <7% of nominal voltage value Temperature coefficient Output voltage temperature coefficient 0.05%/C Turn-on Delay (max) ** 2 Seconds Rise Time Start-up rise time of <20mS to rise to within regulation limits Efficiency 60% minimum at normal input voltage and full load. * Voltage measured P-P at 20MHz and output parallel with 100nF ceramic & 10uF electrolytic capacitors to ground. Temperature at 25C and nominal AC input voltage. ** At nominal AC voltage and full load. Page 1 of 4 www.accesscomms.com.au/specs/adaptor 05Gspec.pdf Copyright 2007 Access Communications Pty Ltd Product Specification sheet 05G Series Plug-in Switch Mode Power Supply Unit MECHANICAL Dimensions 57(H) x 41(W) x 33(D)mm. Weight 85g maximum. Input Plug Type Wall type, SAA 2-pin AS/NZS3112:2000 Output Cord Wire: 22AWG/2C, 2000mm. Output Plug DC Barrel Plug (with fork & groove). 11x5.5x2.1mm ENVIRONMENTAL Cooling Natural convection. Operating Te mperature 0C to +40C Storage Temperature -20C to +80C Operating Humidity 10 ~ 90 % Non-condensing Storage Humidity 10 ~ 90 % Non-condensing SAFETY Dielectric withstanding 3000V AC 10mA for 1 minute.. voltage test (Hi-pot test) input to output Insulation Resistance 10M at 500V DC between Primary Active, Neutral line and secondary. Leakage Current 0.25mA maximum at normal AC input voltage and frequency RELIABILITY Mean Time Between The power supply is designed to have a MTBF of 50,000 hours. Failure (MTBF) Page 2 of 4 www.accesscomms.com.au/specs/adaptor 05Gspec.pdf Copyright 2007 Access Communications Pty Ltd