I-prober 520 positional current probe Unique technology enabling current measurement in PCB tracks ynamic range of 10mA to 20A pk-pk bandwidth of DC to 5MHz, d useable with any normal oscilloscope, safety rated to 300V Cat II investigates waveforms in any conductor including ground planes aimtti.com aimtti.co.uk aimtti.usAim I-prober 520 - a breakthrough in current measurement technology A technology breakthrough The I-prober 520 achieves something radically new. It can observe and measure currents in PCB tracks and other conductors where conventional current probes cant be used. This includes captive wires into components, the legs of integrated circuits, and PCB ground planes. Conventionally, current can only be measured by either breaking the circuit to insert a shunt resistor, or by surrounding the conductor by a loop of magnetic material as in a standard current probe. The I-prober 520 enables currents, from dc up to 5MHz, to be observed and measured simply by placing its insulated tip onto the conductor. Key Features Unique Capabilities Current measurement from insulated probing of conductor No requirement to break or surround the conductor Suitable for observation and measurement of current in Observe and measure currents in PCB tracks directly PCB tracks, component leads and ground planes Minimal disturbance to circuit conditions through very Wide dynamic range of 10mA to 20A peak to peak low insertion impedance and stray capacitance Wide bandwidth of DC to 5MHz Useable in confined and difficult to access spaces Low noise figure equivalent to <6mA rms at full bandwidth Measures current into surface mount components, IC legs and short component leads Safety rated to 300V Cat II (600V Cat I) Can observe currents flowing within ground planes Suitable for connection to any oscilloscope Useable on high voltage conductors and in high High accuracy general purpose H-field probe temperature areas Converts to standard closed magnetic circuit current probe