AIM & THURLBY THANDAR INSTRUMENTS TGR6000 6GHz RF signal generator - CW with sweep 10MHz to 6,000MHz at -110Bm to +7dBm High purity output with low phase noise Custom level trim of up to 100 points Fast full-range sweep using step or list modes Remote control via RS232, USB, GPIB and LAN interfaces aimtti.com aimtti.co.uk aimtti.usTGR6000 - 6GHz RF signal generator for CW and swept/stepped CW applications Cost Effective Solution 10MHz to 6000MHz frequency range The TGR6000 is a low-cost RF signal generator with a maximum frequency of o o Accuracy better than 1ppm over 15 C to 30 C 6GHz. It is intended for CW (carrier wave) applications where modulation is not required, and avoids the costs associated with adding modulations. Ageing better than 1 ppm over one year Low phase noise is matched by low leakage, low residual FM and spurii. The External frequency reference input internal timebase has a 1ppm stability, and an external frequency reference Low phase noise and low leakage can be used for higher precision. -110dBm to +7dBm amplitude, 0.1dB steps Flexible Sweep Modes Amplitude entry in dBm, V / mV, or dBV The TGR6000 incorporates an advanced stepped sweep system which allows User compensation tables for specific test set-ups both frequency and amplitude to be swept. The sweep can be defined in terms of start and stop frequency/amplitude Fast stepping sweep with dwell times down to 10ms points with linear or logarithmic interpolation between them. The total Internal or externally triggered sweep, lin or log, up or down number of points can be set from 2 to 1000 and the dwell time between points List sweep of up to 1000 points of amplitude vs frequency can be set from 10ms up to 10s. Sweeps can be triggered manually, from an internal timer or from the remote Storage for 12 generator set-ups and 16 sweep lists interfaces. If required, each point within the sweep can be stepped via a Compact half-rack 2U casing uses minimum bench space trigger event rather than a fixed time. Full remote control through RS232, USB, LAN or GPIB In List Sweep mode, the sweep is defined by a table of up to 1000 frequency/ amplitude points which can be stepped between either by trigger events or by Significantly lower cost than other 6GHz generators an individual dwell time for each point. This system provides the flexibility to generate changes in frequency and Set-up and Sweep List Storage amplitude to match virtually any required test pattern. The generator has internal storage for up to 12 complete instrument Lists can be generated within the instrument, or on a PC and downloaded set-ups and up to 16 sweep lists. via the interfaces. Up to 16 user lists can be stored permanently within the instruments memory. Set-ups and sweep lists can be given user defined names if required. Full Remote Control User Compensation Table (Trim) The TGR6000 incorporates full remote control using USB, RS-232, GPIB and The Trim function enables the output level to be adjusted in order to calibrate LAN (Ethernet) interfaces. an entire test set up. The Trim function consists of a user programmable list of up to 100 amplitude adjustment /frequency pairs. When turned on, it adjusts the output level by an amount linearly interpolated between the frequencies specified in the list. Compact for Bench or Rack Ease of Use The generator is housed in The TGR6000 is both simple and intuitive to use. a 2U high half-rack width Frequency and level can be entered directly from the keyboard in whichever case the uses the minimum units are preferred. Alternatively values can be changed in user defined of bench space. increments using the spin wheel or up/down keys. A rack mounting kit is The four line display has available. soft key functionality for setting up more complex functions such as sweep lists.