Click on Series name for product info on aimtec.com Series AMER150C-AZ up to 6.3A AC-DC / DC-DC LED Driver / Converter FEATURES: AC-DC Constant Current or Constant Over Voltage Protection Voltage LED Driver Over Current Protection Input range 90-305VAC/47-440Hz Waterproof Case rated IP68 High Efficiency up to 89% Power Factor Correction Operating temperature -40 to 80C Short Circuit Protection Dimmable via resistive / 0-10Vdc / PWM Over Temperature Protection 5 Years Limited Warranty Models Single output Max Output Efficiency Output Input Input Output Voltage (%) Current Model Voltage Voltage Mode of Operation Power Range 115 230 277 (A) (VAC/Hz) (VDC) (W) (V) VAC VAC VAC Constant Current 87 89 89 AMER150C-50300AZ 150 36-50 0-3 90-305/47-440 130-430 Constant Voltage 87 88 89 Constant Current 86 88 88 AMER150C-42350AZ 147 21-42 0-3.5 90-305/47-440 130-430 86 88 88 Constant Voltage Constant Current 86 88 88 AMER150C-36420AZ 150 24-36 0-4.16 90-305/47-440 130-430 Constant Voltage 86 88 88 Constant Current 85 87 87 AMER150C-24630AZ 144 12-24 0-6.3 90-305/47-440 130-430 Constant Voltage 85 87 87 Exceeding the maximum output power will permanently damage the converter The dimming feature is not supported when units are used in Constant Voltage mode only, In constant current mode output current is maximum shown, in constant voltage mode output voltage is the maximum shown. All models can be ordered with optional North American colour input wires (add NA to part number when ordering) NOTE: Aimtec limited warranty of 5 years is valid based on product operation at datasheet specifications at ambient temperature of 25C, humidity<75%, nominal input voltage (115/230/277VAC) and at rated output load unless otherwise specified. See Series AMER150C-AZ up to 6.3A AC-DC / DC-DC LED Driver / Converter Output Specifications Parameters Conditions Typical Maximum Units Current accuracy 3 % Line regulation LL-HL 2 % Load regulation 0-100% load 3 % Ripple & Noise 200 mV p-p Hold-up time (min) 40 ms Current adjustment range 100-10 % PWM dimming frequency 100-3,000 Hz Analogue dimming 0-10 V Ripple and Noise are measured at 20MHz bandwidth by using a 0.1 F (M/C) or (C/C) and 47F (E/C) parallel capacitor. Isolation Specifications Parameters Conditions Typical Maximum Units I/O 3sec 3750 VAC Tested voltage I/FG 2000 VAC O/FG 500 VAC Isolation resistance 500 VDC >100 M General Specifications Parameters Conditions Typical Maximum Units Switching frequency 125 KHz Over current protection 105 Over voltage protection 105 Short circuit protection Auto recovery o Over temperature protection Detect transformer temperature 125C C o Operating temperature See derating table -40 to +80 C o Maximum case temperature 100 C o Storage temperature -40 to +95 C o Temperature coefficient 0.02 % / C Cooling Free air convection Humidity Non condensing 20 - 95 % RH Case material Aluminum Potting Epoxy (IP68 rated) Wires UL1015 18AWG input & 14AWG output *20CM Weight 900 g Dimensions (L X H X W) 7.13 x 2.32 x 1.85 inches 181.00 x 59.00 x 47.00 mm MTBF >400,000 hrs (MIL-HDBK-217F at +25C) Safety Specifications Parameters Meets UL8750, UL60950-1, EN55022, class B, EN60529(IP68), EN61347-1, EN61347-2-13 Information Technology Equipment EN55022 Class B Harmonic Current Emissions IEC/EN 61000-3-2, Class C Voltage fluctuations and flicker IEC/EN 61000-3-3, (EN60555-3) Electrostatic Discharge Immunity IEC 61000-4-2 Level 3 Standards RF, Electromagnetic Field Immunity IEC 61000-4-3 Level 2 Electrical Fast Transient / Burst Immunity IEC 61000-4-4 Level 2 Surge Immunity IEC 61000-4-5 Level 3 RF, Conducted Disturbance Immunity IEC 61000-4-6 Level 2 Power frequency Magnetic Field Immunity IEC 61000-4-8 Level 1 Voltage dips, Short Interruptions Immunity IEC 61000-4-11 www.aimtec.com Tel: +1 514 620 2722 Toll free: + 1 888 9 AIMTEC (924 6832) F 052.1e R3.F 2 of 7 North America only