SDKNA20700 ALPS

Dual-in-line Package Type Detector Slide Push Rotary Power Detector Slide Push Rotary Power Dual-in-line Push Rocker Slide Rotary Package Type Type Type Type Type 0.5A 125V AC Qualified Type SDKN Compact and low-profile for primary / secondary switching with compatibility to low level rating Ratings and Safety Standards Items Specifications Ratings satisfying local electrical 0.5A 125V AC 0.25A 250V AC appliance and material safety law DC ratings 5mA 5V DC Product Line Minimum order unitpcs. Circuit Total travel Mounting Operation Drawing Rating Operating force Product No. arrangement mm method type No. Japan Export 9 3.51N Push SDKNA20900 1 0.5A 125V AC SPDT 0.25A 250V AC Snap-in 250 1,250 5mA 5V DC 9.7 21.5N Lever SDKNA20700 2 Note Safety standard approval must be obtained as a set. Packing Specifications Bulk Number of packages pcs. Export package measurements mm 1 case /Japan 1 case /export packing 250 1,250 389276380 Dimensions Unit:mm No. Style Mounting hole dimensions Push 25 11.3 22.9 On position of circuitc-1 13 8.5 11.3 Off position of circuitc-2 6 Total travel 7.9 position 4.2 1 Direction of insertion 1.7 t=0.8-1.5mm Terminal No.c Terminal No.1 11 Terminal No.2 164 R R1 15 15.75 6.5 15 2 12.5min. 14.4min. 11.2 tPush Rocker Slide Rotary Dual-in-line Package Type Type Type Type Type Detector Slide Push Rotary Power Dual-in-line Detector Slide Push Rotary Power Package Type R 0.8 SDKN0.5A 125V AC Qualified Type Dimensions Unit:mm No. Style Mounting hole dimensions 25 11.3 Lever 22.9 Within the ON range of the C-1 circuit 11 5.1 Total travel Within the OFF range of the C-2 circuit position 1.7 1.8 1.7 2 Direction of insertion t=0.8-1.5mm Terminal No.1 11 Terminal No.2 Terminal No.C Note Circuit Diagram Connector corresponds to HLP-03V , manufactured by the J.S.T. Mfg. Co., Ltd. SPDT C 2 1 0.5A 125V AC Qualified Type / Cautions 1. This product does not have a water-proof or drip-proof construction. Prevent ingress of water into the switch. Avoid using around spilt or flowing. It may cause deterioration of the insulation. 2. Do not apply load on the connecter or lead wirecodeattached to the product. Using the product with load applied on the connecter / lead wire might cause terminal wobble or contact failures. 3. ON / OFF signal readingFor DC ratings Shall be considered when designing circuit and software as follows. 1 Setting of thresh voltage A 4V or larger voltage difference between switch ON and OFF is recommended. Thresh voltage should be set to the center. 4V Thresh voltage 0V 2 ON / OFF signal reading ON / OFF signal reading intervals should be at a minimum of 50ms with at least 3 repetitions. Reading of micro-computer Times 1 23 50ms min. 4. Verify the performance under actual product conditions before use. 165 R R1 15 15.5 5.5 3 2 15 12.2 min. 14.1 min. 11.2 t