NUMBER TYPE GS-12-316 PRODUCT SPECIFICATION TITLE PAGE REVISION 1 of 7 C AUTHORIZED BY DATE Low Profile Smart Card Connectors Miao SH 01/21/09 1.0 OBJECTIVE 1.1 This specification defines the performance, test, quality and reliability requirements of the smart card connector product. 2.0 SCOPE This specification is applicable to the termination characteristics of the smart card connector family of products which provides interconnection between a smart card and a 1.57 mm rigid PCB. 3.0 GENERAL This document is composed of the following sections: 1.0 Objective 2.0 Scope 3.0 General 4.0 Applicable Documents 5.0 Requirements 5.1 Qualification 5.2 Mechanical performance 5.3 Electrical performance 5.4 Environmental Conditions 6.0 Quality assurance provisions 6.1 Equipment Calibration 6.2 Inspection Conditions 7.0 Revision history Copyright 20XX FCI Taiwan, INC. Form E-3334 Rev A 02/12/01 GS-12-234 V20603 PDM: Rev:C Released .STATUS: Printed: Nov 28, 2010NUMBER TYPE GS-12-316 PRODUCT SPECIFICATION TITLE PAGE REVISION 2 of 7 C AUTHORIZED BY DATE Low Profile Smart Card Connectors Miao SH 01/21/09 4.0 APPLICABLE DOCUMENTS 4.1 Specifications 4.1.1 FCI engineering drawing. 4.2 Other Standards and Specifications 4.2.1 UL94-V0: Flammability 4.2.2 IEC 512: Testing procedures & measurement methods for electrical products. 4.2.3 ISO 7816: Smart card standard 4.3 FCI Specifications BUS-02-056: Metal Selection BUS-02-057: Plating Selection Guidelines 5.0 REQUIREMENT 5.1 Qualification Connectors produced under this specification shall be capable of meeting the qualification test requirements specified herein. 5.1.1 Material The material for each component shall be as specified herein or equivalent. Reference: BUS-02-055 BUS-02-056 and BUS-02-058. 5.1.1.1 Terminal: The base material shall be phosphor bronze. 5.1.1.2 Cover: PA46 or PBT 5.1.1.3 Base: PC or PBT 5.1.2 Terminal finish 5.1.2.1 Under plating: 50 nickel over all 5.1.2.2 Signal terminal: 80 gold minimum on mating area 120 tin/lead on solder tail. 5.1.2.3 Sensor terminal: 15 gold minimum on mating area 120 tin/lead on solder tail, 5.1.3 Design and Construction Connectors shall be of the design, construction, and physical dimensions specified in the applicable product drawing and the card standard described in ISO 7816, GSM 11.11 The connection between the smart card and the connector is accomplished by cantilever contacts. The detection of the card end position is obtained by a blade switch,normally open or closed. Copyright 20XX FCI Taiwan, INC. Form E-3334 Rev A 02/12/01 GS-12-234 V20603 PDM: Rev:C Released .STATUS: Printed: Nov 28, 2010