TYPE NUMBER GS-12-175 PAGE PRODUCT SPECIFICATION 1 OF 7 REV: B AUTHORIZED BY DATE TITLE SMART PLUS B CONNECTOR KENNY TAI 05/20/ 04 1.0 OBJECTIVE 1.1 This specification defines the performance, test, quality and reliability requirements of the smart card connector product. 2.0 SCOPE This specifies is applicable to the termination characteristics of the smart card connector family of products which provides interconnection between smart card printed wiring boards. 3.0 GENERAL This document is composed of the following sections : 1.0 Objective 2.0 Scope 3.0 General 4.0 Applicable Documents 5.0 Requirements 5.1 Qualification 5.2 Material 5.3 Finish 5.4 Design and Construction 6.0 Electrical Characteristics 7.0 Mechanical characteristics 8.0 Environmental Conditions 9.0 Quality assurance provisions 9.1 Equipment Calibration 9.2 Inspection Conditions 9.3 Sample Quantity and Description 9.4 Acceptance 9.5 Qualification Testing 9.6 Requalification Testing 10.0 Reference Documents TABLE 1 Qualification testing matrix NOTE THIS DOCUMENT IS THE PROPERTY OF AND EMBODIES PROPRIETARY INFORMATION OF THE BERG ELECTRONICS COMPANY. NO PART OF THE INFORMATION SHOWN ON THIS DOCUMENT MAY BE USED IN ANY WAY WITHOUT THE WRITTEN CONSENT OF BERG ELECTRONICS. PDM: Rev:B Released .STATUS: Printed: Nov 28, 2010 E-3005 REV 4/7/93 TYPE NUMBER GS-12-175 PAGE PRODUCT SPECIFICATION 2 OF 7 REV: B AUTHORIZED BY DATE TITLE SMART PLUS B CONNECTOR KENNY TAI 05/20/ 04 4.0 APPLICABLE DOCUMENTS 4.1 Specifications 4.1.1 Engineering drawings 55640 4.2 Other Standards and Specifications 4.2.1 UL94-HB: Flammability 4.2.2 EIA 364: Electrical Connector/Socket Test Procedures Including Environmental Classifications. 4.2.3 ANSI-J-002: Joint Industry Standard, Solderability Test for Component Leads, Terminations, Lugs, and Terminals and Wires. 4.2.4 IEC 68-2: International Electrotechnical Commission for Environmental testing. 4.2.5 ISO 7816: Smart card standard 4.3 FCI Specifications VGN 11428/A BUS-02-055 BUS-02-056 BUS-02-057 BUS-02-058 5.0 REQUIREMENT 5.1 Qualification Connectors furnished under this specification shall be capable of meeting the qualification test requirements specified herein. 5.2 Material The material for each component shall be as specified herein or equivalent. Reference BUS-02-055 BUS-02-056 and BUS-02-058. 5.2.1 Terminal: The base material shall be phosphor bronze. 5.2.2 Insulating Housing: The insulators shall be high performance PCB that are rated 94V-0 or better in accorclance with UL-94. 5.3 Finish The finish for applicable components shall be as specified herein or equivalent. Reference BUS-02-057. 5.3.1 Terminals Contact coating ( 0.8 m Gold), over 1.3m Nickel. 5.4 Design and Construction Connectors shall be of the design, construction, and physical dimensions specified on the applicable product drawing and the card standard described in ISO 7816, GSM 11.11 NOTE THIS DOCUMENT IS THE PROPERTY OF AND EMBODIES PROPRIETARY INFORMATION OF THE BERG ELECTRONICS COMPANY. NO PART OF THE INFORMATION SHOWN ON THIS DOCUMENT MAY BE USED IN ANY WAY WITHOUT THE WRITTEN CONSENT OF BERG ELECTRONICS. PDM: Rev:B Released .STATUS: Printed: Nov 28, 2010 E-3005 REV 4/7/93