AS5600L-ASOM ams

AS5600L 12-Bit Programmable On-Axis Magnetic Rotary Position Sensor The AS5600L is an easy to program magnetic rotary position General Description sensor with a high-resolution 12-bit IC or PWM output. This contactless system measures the absolute angle of a diametric magnetized on-axis magnet. This AS5600L is designed for contactless potentiometer applications and its robust design eliminates the influence of any homogenous external stray magnetic fields. The industry-standard IC interface supports simple user programming of non-volatile parameters without requiring a dedicated programmer. By default the output represents a range from 0 to 360 degrees. It is also possible to define a smaller range to the output by programming a zero angle (start position) and a maximum angle (stop position). The AS5600L is also equipped with a smart low power mode feature to automatically reduce the power consumption. An input pin (DIR) selects the polarity of the output with regard to rotation direction. If DIR is connected to ground, the output value increases with clockwise rotation. If DIR is connected to VDD, the output value increases with counterclockwise rotation. The AS5600L is available in a standard SOIC-8 package and in a WL-CSP for applications requiring small-sized sensing solutions with a size of 2.07mm x 2.63mm x 0.6mm. Both variants are qualified for a temperature range from -40C to 125C. Ordering Information and Content Guide appear at end of datasheet. Key Benefits & Features The benefits and features of AS5600L, 12-bit Programmable Contactless Potentiometer are listed below: Figure 1: Added Value of Using AS5600L Benefits Features Highest reliability and durability Contactless magnetic angle measurement Easy programming of start and stop positions in 3-wire mode Simple programming (no programmer needed) or over the IC interface Multiple sensors on one IC bus User programmable IC address ams Datasheet Page 1 v1-12 2020-May-14 Document FeedbackAS 560 0L Gen e ra l De s c rip t ion Benefits Features Great flexibility on angular excursion Maximum angle programmable from 18 up to 360 High-resolution output signal 12-bit output resolution available on IC and PWM output Low-power consumption Automatic entry into low-power mode Easy setup Automatic magnet detection Very small form factor WL-CSP (2.07mm x 2.63mm) or SOIC-8 package Robust environmental tolerance Wide temperature range: -40C to 125C Applications The AS5600L is ideally suited for contactless potentiometers, contactless knobs, pedals, RC servos and other angular position measurement solutions. Block Diagram The functional blocks of this device are shown below: Figure 2: Functional Blocks of AS5600L VDD3V3 SDA SCL DIR Low-Dropout (LDO) Regulator VDD5V Register Setting (internal load only) I2C Address IC Automatic low power mode One-Time Programmable (OTP) Memory Analog Hall Sensors Front-End Automatic ATAN AFE 12-bit A/D Digital Processing PWM Driver OUT PWM (CORDIC) and Filtering Automatic Gain Control (AGC) Magnetic Core AS5600L GND Page 2 ams Datasheet Document Feedback v1-12 2020-May-14