HUB-T Amseco

HUB-T HOLD-UP BUTTON UL & CUL Listed Dimensions: 2 1/16 W x 3 7/16 L x 1 1/4 H 52,4 cm W x 87,3 cm L x 2,7 cm H Weight: 2.4 oz. 68,0 g. Switch Rating: 3 Amps at 28V DC/AC .05 Amp at 125V DC Resistive Enclosure: ABS Plastic Temperature Range: 32F to 140F (85% maximum humidity) Environmental Limitations: Not recommended for outdoor use or use in coolers or freezers. Stock No. 2020132 The HUB-T Series Hold-Up Buttons provide two sets of momentary Converting The HUB-T To Optional Latching Operation Remove the installed button caps and discard. Replace with alternate or latching DPDT contacts for actuating surveillance cameras or other security applications, in addition to the hold-up signal. The two sets latching caps (supplied). Align the cap such that the latching of contacts may be used independently of each other, or they may be mechanism is directly over the latching ramp in the base. wired in series with a jumper wire for additional protection against See illustration at right. false alarms. See illustration on page 2. Installation Install in accordance with UL 681. Devices should be installed so they cannot be observed by the public and so they can be operated inconspicuously. At least one shall be installed in each vault open during business hours. In banks they shall also be installed in of ces DWG 996-6 commanding a view of the public space. HUB-T (Shown without cover) LATCHING CAP LATCHING RAMP BREAK OUT FOR SURFACE MOUNT WIRING ADD JUMPER WIRE HUB-T (Shown with cover) To unlatch the HUB-T, insert the reset key, provided with the HUB-T, between the switch cap and the base. The unit unlatches when the cap is released. WIRE EXIT WIRE EXIT AREA AREA DWG 996-1 BREAK OUT FOR SURFACE MOUNT WIRING Potter Electric Signal Company 2081 Craig Road, St. Louis, MO, 63146-4161 Phone: 800-325-3936/Canada 888-882-1833 www.pottersignal.com PRINTED IN USA MKT 8900085 - REV L PAGE 1 OF 2 8/02HUB-T HOLD-UP BUTTON HUB-T (Shown without cover) Normally Open Hold-up Circuit With EOL Supervision Normally Closed Hold-up Circuit With EOL Supervision BREAK OUT FOR SURFACE MOUNT WIRING TO CAMERA TRIGGER TO CAMERA TRIGGER WIRE EXIT AREA TO HOLD-UP ZONE DWG 997-1 TO HOLD-UP ZONE Electrical interlock requires both buttons to be activated simultaneously before alarm will occur. Any single button will activate camera. Note: Jumpers required PRINTED IN USA MKT 8900085 - REV L PAGE 2 OF 2 8/02