ADSP-CM419F EZ-KIT Manual Revision 1.0, April 2016 Part Number 82-000723-01 Analog Devices, Inc. One Technology Way Norwood, MA 02062-9106Copyright Information 2016 Analog Devices, Inc., ALL RIGHTS RESERVED. This document may not be reproduced in any form without prior, express written consent from Analog Devices, Inc. Printed in the USA. Disclaimer Analog Devices, Inc. reserves the right to change this product without prior notice. Information furnished by Ana- log Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its use nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under the patent rights of Analog Devices, Inc. Trademark and Service Mark Notice The Analog Devices logo, Blackfin, Blackfin+, SHARC, SHARC+, CrossCore, VisualDSP++, EZ-KIT, EZ-Extend- er, and EngineerZone are registered trademarks of Analog Devices, Inc. All other brand and product names are trademarks or service marks of their respective owners. Regulatory Compliance The ADSP-CM419F EZ-KIT is designed to be used solely in a laboratory environment. The board is not inten- ded for use as a consumer-end product or as a portion of a consumer-end product. The board is an open system design, which does not include a shielded enclosure and, therefore, may cause interference to other electrical devices in close proximity. This board should not be used in or near any medical equipment or RF devices. The ADSP-CM419F EZ-KIT is in the process of being certified to comply with the essential requirements of the European EMC directive 2004/108/EC and, therefore, carries the CE mark. i ADSP-CM419F EZ-KIT Manual