DS1135LU-20+ Analog Devices

DS1135L 3V 3-in-1 High-Speed Silicon Delay Line FEATURES PIN ASSIGNMENT All-Silicon Timing Circuit Three Independent Buffered Delays Stable and Precise Over Temperature and 1 8 IN1 V CC Voltage 2 IN2 7 Leading and Trailing Edge Precision OUT1 Preserves the Input Symmetry 3 6 OUT2 IN3 Vapor Phase and IR Reflow Solderable 4 5 OUT3 GND Available in Tape and Reel DS1135LZ 8-Pin SO (150 mils) Delays Specified Over Both Commercial and Industrial Temperature Ranges 3V Operation Recommended Replacement for DS1033 PIN DESCRIPTION IN1-IN3 - Input Signals OUT1-OUT3 - Output Signals V - +3V Supply CC GND - Ground DESCRIPTION The DS1135L series is a low-power, 3V high-speed version of the popular DS1013, DS1033, and DS1035 series. The DS1135L series of delay lines have three independent logic buffered delays in a single package. The device is our fastest 3-in-1 delay line. It is available in a 150-mil 8-pin SO. The device features precise leading and trailing edge accuracy. It has the inherent reliability of an all- silicon delay line solution. Standard delay values are indicated in Table 1. 1 of 6 19-6412 Rev 8/12 DS1135L LOGIC DIAGRAM Figure 1 IN OUT TIME DELAY ONE OF THREE PART NUMBER DELAY TABLE (t , t ) Table 1 PLH PHL TOLERANCE OVER DELAY PER INITIAL TEMP AND VOLTAGE PART NUMBER OUTPUT TOLERANCE (Note 2) (ns) (Note 1) 0C to +70C -40C to +85C 10/10/10 DS1135LZ-10+ 1.0ns 2.0ns 3.0ns DS1135LZ-12+ 12/12/12 1.0ns 2.0ns 3.0ns DS1135LZ-15+ 15/15/15 1.0ns 2.5ns 4.0ns DS1135LZ-20+ 20/20/20 1.0ns 2.5ns 4.0ns 25/25/25 DS1135LZ-25+ 1.5ns 3.0ns 5.0ns 30/30/30 DS1135LZ-30+ 1.5ns 3.0ns 5.0ns +Denotes a lead(Pb)-free/RoHS-compliant package. NOTES: 1. Nominal conditions are +25C and V = +3.3V. CC 2. Voltage range of 2.7V to 3.6V. 3. Delay accuracies are for both leading and trailing edges. TEST SETUP DESCRIPTION Figure 2 illustrates the hardware configuration used for measuring the timing parameters of the DS1135L. The input waveform is produced by a precision pulse generator under software control. Time delays are measured by a time interval counter (20 ps resolution) connected to the output. The DS1135L output taps are selected and connected to the interval counter by a VHF switch control unit. All measurements are fully automated with each instrument controlled by the computer over an IEEE 488 bus. 2 of 7