DS1135Z-12+ Analog Devices

DS1135 3-in-1 High-Speed Silicon Delay Line FEATURES PIN ASSIGNMENT All-Silicon Timing Circuit Three Independent Buffered Delays V IN1 1 CC 8 Stable and Precise Over Temperature and IN2 2 OUT1 7 Voltage 3 OUT2 IN3 6 Leading and Trailing Edge Precision OUT3 Preserves the Input Symmetry GND 4 5 Vapor Phasing, IR, and Wave Solderable DS1135Z 8-Pin SO (150 mils) Available in Tape and Reel Commercial and Industrial Temperature Ranges Available 5V Operation (Refer to DS1135L for 3V PIN DESCRIPTION Operation) IN1-IN3 - Input Signals Recommended Replacement for DS1013 OUT1-OUT3 - Output Signals and DS1035 V - +5V Supply CC GND - Ground DESCRIPTION The DS1135 series is a low-power, +5V high-speed version of the popular DS1013 and DS1035. The DS1135 series of delay lines have three independent logic buffered delays in a single package. The device is our fastest 3-in-1 delay line. It is available in a standard 8-pin 150-mil SO. The device features precise leading and trailing edge accuracy. It has the inherent reliability of an all- silicon delay line solution. Each output is capable of driving up to 10 LS loads. Standard delay values are indicated in Table 1. 1 of 7 19-6411 Rev 8/12 DS1135 LOGIC DIAGRAM Figure 1 IN OUT TIME DELAY ONE OF THREE PART NUMBER DELAY TABLE (t , t ) Table 1 PLH PHL TOLERANCE OVER DELAY PER INITIAL TEMP AND VOLTAGE PART NUMBER OUTPUT TOLERANCE (Note 2) (ns) (Note 1) 0C to +70C -40C to +85C DS1135Z-6+ 6/6/6 1.0ns 1.0ns 1.5ns DS1135Z-8+ 8/8/8 1.0ns 1.0ns 1.5ns DS1135Z-10+ 10/10/10 1.0ns 1.0ns 1.5ns DS1135Z-12+ 12/12/12 1.0ns 1.0ns 1.5ns DS1135Z-15+ 15/15/15 1.0ns 1.5ns 2ns DS1135Z-20+ 20/20/20 1.0ns 1.5ns 2ns DS1135Z-25+ 25/25/25 1.5ns 1.5ns 2ns DS1135Z-30+ 30/30/30 1.5ns 1.5ns 2ns NOTES: 1. Nominal conditions are +25C and V =+5.0V. CC 2. Voltage range of 4.75V to 5.25V. 3. Delay accuracies are for both leading and trailing edges. TEST SETUP DESCRIPTION Figure 2 illustrates the hardware configuration used for measuring the timing parameters of the DS1135. The input waveform is produced by a precision pulse generator under software control. Time delays are measured by a time interval counter (20ps resolution) connected to the output. The DS1135 output taps are selected and connected to the interval counter by a VHF switch control unit. All measurements are fully automated with each instrument controlled by the computer over an IEEE 488 bus. 2 of 7