Evaluates: DS4402/DS4404 DS4404 Evaluation Kit General Description Features 2 The DS4404 and DS4402 contain two or four I C- Easy Evaluation of the DS4404 programmable current DACs that are each capable of EV Kit Hardware is USB Powered sinking and sourcing current. USB HID Interface The DS4404 evaluation kit (EV kit) provides the hardware Windows XP- and Windows 7-Compatible and software graphical user interface (GUI) necessary to Software evaluate the DS4404 4-channel, 5-bit sink/source current RoHS Compliant DAC. The DS4402 has the same performance as the DS4404, except with only two channels. The DS4404 EV Proven PCB Layout kit software is the same as the DS4424 EV kit software. Fully Assembled and Tested The EV kit includes a DS4404 installed, as well as two pop- ulated full-scale calibration resistors (R3 and R4) and two EV Kit Contents unpopulated resistors (R5 and R6). This allows the device Assembled Circuit Board Including DS4404 to be evaluated without any board rework on two channels, but enables a custom-defined value to be populated on the 2 Ordering Information appears at end of data sheet. two open channels. The EV kit also has the USB-to-I C interface required to communicate to the device. DS4404 EV Kit Photo Windows and Windows XP are registered trademarks and registered service marks of Microsoft Corporation. 19-7385 Rev 0 4/14Evaluates: DS4402/DS4404 DS4404 Evaluation Kit 3) Windows should automatically begin installing the DS4404 EV Kit Files necessary device driver. The USB interface of the EV FILE DESCRIPTION kit hardware is configured as an HID device and there- DS4424EVKitSoftwareInstall.EXE Application program fore does not require a unique/custom device driver. Once the driver installation is complete, a Windows Note: The .EXE file is downloaded as a .ZIP file. message appears near the System Icon menu, indicating that the hardware is ready to use. Do not Quick Start attempt to run the GUI prior to this message. If you do, then you must close the application and restart it once Required Equipment the driver installation is complete. On some versions DS4404 EV kit hardware of Windows, administrator privileges may be required Windows XP or Windows 7 PC to install the USB device. USB port 4) Once the device driver installation is complete, Micro-USB cable visit www.maximintegrated.com/evkitsoftware to download the latest version of the EV kit software, Note: In the following sections, software-related items are DS4424EVKitSoftwareInstall.ZIP. Save the EV kit identified by bolding. Text in bold refers to items directly software to a temporary folder. from the install or EV kit software. Text in bold and under- lined refers to items from the Windows operating system. 5) Open the .ZIP file and double-click the .EXE file to run the installer. A message box stating The publisher Procedure could not be verified. Are you sure you want to run The EV kit is fully assembled and tested. Follow the steps this software may appear. If so, click Yes. below to verify board operation: 6) The installer GUI appears. Click Next and then 1) Place the EV kit hardware on a nonconductive Install. Once complete, click Close. surface to ensure that nothing on the PCB gets 7) Go to Start All Programs. Look for the shorted together. DS4424EVKitSoftware folder and click on the 2) Prior to starting the GUI, connect the EV kit hardware DS4424EVKitSoftware.EXE inside the folder. to a PC using the mini-USB cable, or equivalent. The 8) When the GUI appears, the text in the bottom power LED (D20) should be green and the com LED right-hand corner should display EV Kit Hardware (D21) should be red and slowly flash orange. Connected. The com LED (D21) on the EV kit board should turn green. Maxim Integrated 2 www.maximintegrated.com