EVAL-ADA4571-2 User Guide UG-1047 One Technology Way P.O. Box 9106 Norwood, MA 02062-9106, U.S.A. Tel: 781.329.4700 Fax: 781.461.3113 www.analog.com Evaluation Board for the ADA4571-2 Integrated AMR Angle Sensor and Signal Conditioner FEATURES GENERAL DESCRIPTION USB 2.0 interface The EVAL-ADA4571-2 shows the ADA4571-2 in an end of shaft Jumper or computer controlled temperature compensation magnet configuration. The evaluation kit is composed of an mode enable ADA4571-2 motherboard, a magnetic stimulus on a hand turnable Jumper or computer controlled power-down mode enable mount, a USB interface, and an SDP-S controller board. The Measurement test points and coaxial connectors required LabVIEW 2013 graphical user interface (GUI) software for Windows is available on the ADA4571-2 product page. EVALUATION KIT CONTENTS The EVAL-ADA4571-2 features an on-board 5 V regulator, a ADA4571-2 magnetic stimulus 6-channel simultaneous sampling analog-to-digital converter Dipole magnet (ADC), and jumpers for enabling the temperature compensation Hand movable mounting and power-down modes within the ADA4571-2. The motherboard Read back electronics also features test points and unpopulated coaxial connectors for ADDITIONAL EQUIPMENT NEEDED the six outputs of the device. 6 V to 12 V bench supply (optional) The SDP-S controller board controls the ADC on the motherboard SDP-S controller board reading back the ADA4571-2 outputs, to change the digital inputs USB cable (supplied with the SDP-S controller board) to the ADA4571-2, interface with the GUI, and to supply power LabVIEW 2013 software downloadable from ADA4571-2 to the evaluation board through the USB connection. product page ADA4571-2 END OF SHAFT EVALUATION SYSTEM Figure 1. PLEASE SEE THE LAST PAGE FOR AN IMPORTANT WARNING AND LEGAL TERMS AND CONDITIONS. Rev. 0 Page 1 of 9 15014-001UG-1047 EVAL-ADA4571-2 User Guide TABLE OF CONTENTS Features .............................................................................................. 1 Jumper Configuration ..................................................................4 Evaluation Kit Contents ................................................................... 1 Device Under Test (DUT) Outputs.............................................4 Additional Equipment Needed ....................................................... 1 Evaluation Board Software ...............................................................5 General Description ......................................................................... 1 Starting Up the Evaluation GUI ..................................................5 ADA4571-2 End of Shaft Evaluation System ................................. 1 Overview of the Main GUI Window ..........................................5 Revision History ............................................................................... 2 Evaluation Board Schematic and Artwork .....................................8 Getting Started .................................................................................. 3 Ordering Information .......................................................................9 Software Installation Procedures ................................................ 3 Related Links ......................................................................................9 Evaluation Board Hardware ............................................................ 4 REVISION HISTORY 12/2016Revision 0: Initial Version Rev. 0 Page 2 of 9