EVAL-ADG5249FEBZ Analog Devices

EVAL-ADG5249FEBZ User Guide UG-878 One Technology Way P.O. Box 9106 Norwood, MA 02062-9106, U.S.A. Tel: 781.329.4700 Fax: 781.461.3113 www.analog.com Evaluation Board for the ADG5249F, Overvoltage Protected Dual 4:1 Multiplexer FEATURES GENERAL DESCRIPTION Supply voltages The EVAL-ADG5249FEBZ is the evaluation board for the Dual supply: 5 V to 22 V ADG5249F, which features an overvoltage protected dual 4:1 Single supply: 8 V to 44 V multiplexer. The ADG5249F has overvoltage detection and Protected against overvoltage on source pins protection circuitry on the source pins and is protected against Signal voltages up to 55 V and +55 V signals up to 55 V and +55 V in both the powered and LEDs for visual overvoltage indication unpowered states. Parallel interface compatible with 3 V logic Figure 1 shows the EVAL-ADG5249FEBZ in a typical evaluation On-board LDO regulator for digital supply and control, setup. The ADG5249F is soldered to the center of the evaluation if required board and wire screw terminals are provided to connect to each of the source and drain pins. Three screw terminals power the EVALUATION KIT CONTENTS device, with a fourth terminal used to provide a user defined digital EVAL-ADG5249FEBZ evaluation board logic supply voltage, if required. Alternatively, a low dropout (LDO) DOCUMENTS NEEDED regulator is provided for 5 V digital logic supply and to supply the LEDs, which are mounted to provide visual indication of the ADG5249F data sheet fault status of the switch. EVAL-ADG5249FEBZ user guide Full specifications on the ADG5249F are available in the product EQUIPMENT NEEDED data sheet, which should be consulted in conjunction with this DC voltage source user guide when using the evaluation board. 22 V for dual supply 44 V for single supply Optional digital logic supply: 3 V to 5 V Analog signal source Method to measure voltage, such as a digital multimeter (DMM) PLEASE SEE THE LAST PAGE FOR AN IMPORTANT WARNING AND LEGAL TERMS AND CONDITIONS. Rev. 0 Page 1 of 15 UG-878 EVAL-ADG5249FEBZ User Guide TABLE OF CONTENTS Features .............................................................................................. 1 Power Supply ..................................................................................5 Evaluation Kit Contents ................................................................... 1 Input Signals...................................................................................5 Documents Needed .......................................................................... 1 Output Signals ...............................................................................5 Equipment Needed ........................................................................... 1 Jumper Settings ..................................................................................6 General Description ......................................................................... 1 Switches and 0 Resitors ............................................................6 Revision History ............................................................................... 2 SMB Connectors............................................................................6 Evaluation Board Connection Diagram ........................................ 3 Evaluation Baord Schematics and Artwork ...................................7 Getting Started .................................................................................. 4 Ordering Information .................................................................... 15 Evaluation Board Setup Procedure ............................................ 4 Bill of Materials ........................................................................... 15 Evaluation Board Hardware ............................................................ 5 REVISION HISTORY 9/15Revision 0: Initial Version Rev. 0 Page 2 of 15