Evaluates: MAX11261 MAX11261 Evaluation Kit The peripheral module includes Windows XP , Windows General Description 7, Windows 8.1, and Windows 10-compatible software for The MAX11261PMB peripheral module (Pmod) provides exercising the features of the IC. The peripheral module the necessary hardware to interface to the MAX11261, a GUI allows different sample sizes, adjustable sampling 24-bit, 6-channel, 16ksps, integrated PGA delta-sigma rates, internal or external reference options, and graphing ADC to any system that utilizes Pmod-compatible expan- software that includes the FFT and histogram of the 2 sion ports configurable for I C communication. The sampled signals. peripheral module includes a graphical user interface (GUI) that provides communication from the target device The peripheral module can be powered by a local +3.3V supply and comes installed with a MAX11261ENX+ in a to the PC through the USB2PMB2 . The peripheral module can operate in multiple modes: 36-bump wafer-level package (WLP). Using USB2PMB2 Adapter: In standalone mode, Features the peripheral module is connected to the PC through a Various Sample Sizes and Sample Rates USB2PMB2 adapter board and performs a subset of the Time Domain, Frequency Domain, and Histogram complete peripheral module functions with limitations for Plotting sample rate, sample size, and no support for coherent On-Board Voltage Reference (MAX6071) sampling. Proven PCB Layout 2 User-Supplied I C Mode: The peripheral module Fully Assembled and Tested provides a 12-pin Pmod-style header for user-supplied 2 I C interface to connect the signals for SCL, SDA, RSTB, and RDYB. Ordering Information appears at end of data sheet. MAX11261 EV Board Photo Windows are registered trademarks and registered service marks of Microsoft Corporation. 319-100171 Rev 0 3/18Evaluates: MAX11261 MAX11261 Evaluation Kit Delta-Sigma Modulator block, set Conversion Quick Start Mode to Single Cycle and then click Convert and Required Equipment Read All. (Note: The Scope, DMM, Histogram, and MAX11261PMB1 EV kit (includes micro-USB cable) FFT tabs do not support data capture for Single Cy- cle mode, so the Capture button will be disabled in 2 USB2PMB2 USB to I C interface board this mode.) Windows PC 10) In the Scan Mode tab, inside Read Data group, click Note: In the following sections, software-related items are Scan to ensure that the Conversion mode has been identified by bolding. Text in bold refers to items directly set to Single Cycle. from the EV kit software. Text in bold and underlined 11) In the Sequence Settings group, click Enable All refers to items from the Windows operating system. Channels to configure channels CH0-CH5 to be Procedure scanned in order, with GPO0-5 assigned to individ- ual channels. The channels can be scanned in any The EV kit is fully assembled and tested. Follow the steps order, and the GPOs can be assigned in any order. below to verify board operation: 12) Set Sequence Mode to Mode 2 or Mode 3, then 1) Visit