EVALUATION KIT AVAILABLE MAX15101 Small 1A, Low-Dropout Linear Regulator in a 2.7mm x 1.6mm Package General Description Features The MAX15101 is a small, low-dropout linear regulator 1.7V to 5.5V Operating Range optimized for networking, datacom, and server applica- 100mV Dropout Guaranteed at 1A tions. The regulator delivers up to 1A from a 1.7V to 5.5V 1.6% Output Accuracy Over Line, Load, and input supply with output accuracy of 1.6%. The output Temperature is adjustable down to 0.6V with a guaranteed dropout Adjustable Output from 0.6V to 5.2V voltage of less than 100mV at full load. The internal p-channel switch is protected with a foldback current limit Foldback Current Protection and thermal shutdown. Thermal Shutdown Protection The MAX15101 features an external bypass input to Low Noise 15V (typ) RMS reduce noise. This bypass input also serves as a soft- Small 1.6mm x 2.7mm WLP Package start control. An enable input and power-good output are included for power sequence control. The MAX15101 is available in a 1.6mm x 2.7mm WLP package and is fully specified from the -40C to +85C operating temperature range. Ordering Information appears at end of data sheet. Applications Networking Telecom/Datacom Servers Base Stations PLL Power Typical Operating Circuit INPUT (1.7V TO 5.5V) OUTPUT (0.6V TO V - 200mV) IN IN OUT C C OUT IN MAX15101 R1 2.2F 10F 0 TO 4.6k EN PG FB POWER-GOOD OUTPUT R2 GND SS BYP 600 C SS 100nF 19-6154 Rev 1 8/16MAX15101 Small 1A, Low-Dropout Linear Regulator in a 2.7mm x 1.6mm Package Absolute Maximum Ratings IN, SS BYP, FB to GND .........................................-0.3V to +6V Operating Temperature Range ........................... -40C to +85C EN, PG, OUT to GND ................................-0.3V to (V + 0.3V) Storage Temperature Range ............................ -65C to +150C IN OUT Short Circuit ......................................................Continuous Junction Temperature ......................................................+150C Continuous Power Dissipation (T = +70C) Soldering Temperature (reflow) (Note 1) .........................+260C A WLP (derate 19.2mW/C above +70C) ....................1538mW Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Note 1: The WLP package is constructed using a unique set of package techniques that impose a limit on the thermal profile. The device can be exposed during board-level solder attach and rework. This limit permits only the use of the solder profiles recommended in the industry-standard specification JEDEC 020A, paragraph 7.6, Table 3 for IR/VPR and convection reflow. Preheating is required. Hand or wave soldering is not allowed. Package Thermal Characteristics (Note 2) WLP Junction-to-Ambient Thermal Resistance ( ) ..........30C/W JA Note 2: Package thermal resistances were obtained using the method described in JEDEC specification JESD51-7, using a four-layer board. For detailed information on package thermal considerations, refer to www.maximintegrated.com/thermal-tutorial. Electrical Characteristics (V = 3.3V, V = 1.5V, V = V , I = 100mA, C = 2.2F, C = 22F, T = T = -40C to +85C, typical values are at IN OUT EN IN OUT IN OUT A J T = +25C, unless otherwise noted.) (Note 3) A PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS IN Input Voltage Range V 1.7 5.5 V IN Input Undervoltage Lockout V V rising 1.624 1.69 V IN UV IN Input Undervoltage Lockout V 40 mV IN UV HYS Hysteresis OUT Output Voltage Range V 0.6 5.2 V OUT Load Regulation I = 30mA to 1A 0.1 %/A OUT V = 1.7V to 5.5V, V = 0.6V, IN OUT Line Regulation -0.15 +0.15 %/V I = 190mA OUT Dropout Voltage I = 1A, V = 580mV (Note 4) 25 100 mV OUT FB In-Regulation Current Limit V = 5.5V, V = 500mV 1.62 A IN FB Short-Circuit Foldback Current V = 5.5V, V = 0V, V < 100mV 1 A IN OUT FB Limit Output Shutdown Leakage V = 5.5V, V = 0V, V = 0V 4 A IN OUT EN Line Transient V = 0.5V, t = t = 5s 2 % IN RISE FALL Maxim Integrated 2 www.maximintegrated.com