MAX20330A Precision HV Capable ID Detector General Description Benefits and Features The MAX20330A is an ID detection IC that detects the ID Protects Battery Connected Modules with Minimum resistor values when it is enabled. The device automatically Power Consumption adjusts the detection current to check the wide range of Ultra-Low Shutdown Current: 2.8A (Typ) the ID resistor values while keeping the average supply Ultra-Low ID Detection Current: 2A (Typ) current low. Flexible ID Detection and Support The MAX20330A supports the factory mode for direct Automatic and Manual ID Value Detection Factory Mode Detection system or battery current measurement. The device protects the internal supply from the overvoltage on ID Automatic Device Detection and Interrupt pin up to 40V. ID Overvoltage Protection Blocking High-Voltage Input The device is available in an 8-bump (0.35mm pitch, 1.77mm x 1.03mm) wafer-level package (WLP) and Provides Premium Security in System Reliability operates over the -40C to +85C extended temperature High Input Voltage Tolerant range. Thermal Shutdown Protection Space Saving Applications 8-Bump, 0.35mm Pitch, 1.77mm x 1.03mm WLP Smart Phones Tablet PCs E-Readers Ordering Information appears at end of data sheet. 19-100293 Rev 1 6/18MAX20330A Precision HV Capable ID Detector Absolute Maximum Ratings (All voltages referenced to GND.) Operating Temperature Range ........................... -40C to +85C ID, EN, PCON to GND ..........................................-0.3V to +40V Junction Temperature ......................................................+150C SDA, SCL, INT, V to GND ..................................-0.3V to +6V Storage Temperature Range ............................ -65C to +150C CC Continuous Current into all pins .........................................0.1A Soldering Temperature (reflow) .......................................+260C Continuous Power Dissipation (T = +70C) A WLP (derate 10.9mW/C above +70C) ......................872mW Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Package Thermal Characteristics (Note 1) WLP Junction-to-Ambient Thermal Resistance ( ) .....91.72C/W JA Note 1: Package thermal resistances were obtained using the method described in JEDEC specification JESD51-7, using a four-layer board. For detailed information on package thermal considerations, refer to www.maximintegrated.com/thermal-tutorial. Electrical Characteristics (V = 2.6V to 5.5V, T = -40C to +85C, unless otherwise noted. Typical values are at V = 3.3V, T = +25C) (Note 2) CC A CC A PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS V CC V Voltage Range V 2.6 3.3 5.5 V CC CC V = 4.2V, I = 0mA , manual CC SRC V Supply Current I 130 200 A CC CC detection mode, ENb = 0 V Shutdown Current I V = 4.2V, ENb = 1 2.8 5 A CC CC SHDN CC ID Current Source Current Source Accuracy -5 +5 % Current Source Open ISRC = 2A 2 V Voltage 2 6 18 A Current Source I ID 54 162 2.5 mA 162A max current , Average Current Source I 2 A ID AVG IS PERIOD 130x, ISRC MAN = 0 PCON Open-Drain Voltage 36 V Output Low Voltage V I = 10mA 0.1 0.2 V OL SINK Leakage Current I Open-drain, PCON < ID + 7V 1 A LEAK Maxim Integrated 2 www.maximintegrated.com