MAX20330EVKIT# Analog Devices

MAX20330 Evaluation Kit Evaluates: MAX20330 General Description Quick Start The MAX20330 evaluation kit (EV kit) is a fully assembled Required Equipment and tested circuit board that demonstrates the MAX20330 MAX20330 EV kit programmable OVLO with VBUS short detection device. Power supply The EV kit comes with the MAX20330EWA+ installed. Multimeter Features Procedure OVP or ID Detection The EV kit is fully assembled and tested. Follow the steps Proven PCB Layout below to verify board operation: Fully Assembled and Tested 1) Connect a 3V power supply to VBUS TP1. Check the voltage on OUT. Verify OUT is also 3V. EV Kit Contents 2) Slowly increase VBUS voltage. Verify OUT voltage EV Kit Board Containing a MAX20330 follows VBUS. When VBUS reaches ~6.8V, OUT voltage goes down. 3) Decrease VBUS voltage and OUT voltage comes back to be same as VBUS voltage. Ordering Information appears at end of data sheet. 319-100133 Rev 0 1/18MAX20330 Evaluation Kit Evaluates: MAX20330 2 I C Communication Detailed Description 2 Use JU2, JU3, JU4, JU5, and JU6 to have I C pins pulled The MAX20330 EV kit is a fully assembled and tested cir- 2 up to selected supply. User needs to provide I C master cuit board demonstrating the MAX20330 OVP/ID detector to communicate with the device. The slave address is in an 8-bump wafer-level package (WLP). 0010 111. V Power Supply CC The V can be connected from different power supply CC sources or externally supplied from TP7. Table 1. V Jumper Setting CC JUMPER SHUNT POSITION DESCRIPTION 1-2* VCC is connected to VMC JU1 2-3 VCC is connected to 5VMC *Default Position 2 Table 2. I C Jumper Setting JUMPER SHUNT POSITION DESCRIPTION Installed VIO is connected to VCC JU2 Not installed* VIO is not connected to VCC Installed SCL is pulled up to VIO JU3 Not installed* SCL is not pulled up to VIO Installed SDA is pulled up to VIO JU4 Not installed* SDA is not pulled up to VIO Installed INTB is pulled up to VIO JU5 Not installed* INTB is not pulled up to VIO Installed VIO is connected to VMC JU6 Not installed* VIO is not connected to VMC *Default Position Ordering Information PART TYPE MAX20330EVKIT EV Kit Denotes RoHS compliant. Maxim Integrated 2 www.maximintegrated.com