Click here to ask about the production status of specific part numbers. Evaluates: MAX20360 MAX20360 Evaluation Kit General Description Quick Start The MAX20360 evaluation kit (EV kit) is a fully assembled Required Equipment and tested circuit board that demonstrates the MAX20360 Note: In the following sections, software-related items are ultra low-power wearable power management integrated identified by bold text. Text in bold refers to items directly circuit (PMIC). The MAX20360 includes voltage regula- from the install of EV kit software. tors such as bucks, boost, buck-boost, and linear regula- MAX20360 EV kit tors, and a complete battery management solution with battery seal, charger, power path, and fuel gauge. Windows PC with USB ports 2 The device is configurable through an I C interface that One USB A to USB micro-B cable and allows for programming various functions and read- MAXPICO2PMB adapter board ing device status. The EV kit GUI application sends One USB A to USB micro-B cable or power supply commands to the MAXPICO2PMB adapter board to (for battery simulation or battery voltage) configure the device. Optional one USB A to USB micro-B cable or power The MAX20360EVKIT has no harvester feature. The supply (for charger input CHGIN) MAX20360HEVKIT has a harvester feature enabled and Voltmeter can be connected to MAX20361EVKIT to evaluate the interaction between the two devices. Procedure The EV kit is fully assembled and tested. To verify board Features operation, follow these steps: USB Power Option 1) Visit Evaluates: MAX20360 MAX20360 Evaluation Kit 6) Use a voltmeter to check VHC is approximately 5V 7) On the computer, open the MAX20360 GUI. For the BATSIM test point is approximately 3.7V. To adjust MAX20360EVKIT , the status bar on the bottom the BATSIM voltage, turn the R58 BATSIM potenti- displays MAX20360 Not Found (Figure 1). The IC is ometer. Place shunt on JP9, then confirm that TP1 in Seal Mode. CSN is the set BATSIM voltage. For the MAX20360HEVKIT , the status bar on the bottom displays Connected (Figure 2). The IC is in Battery Recovery Mode. Figure 1. MAX20360 Not Found Status Maxim Integrated 2 www.maximintegrated.com