Evaluates: MAX2120 MAX2120 Evaluation Kit General Description Features The MAX2120 evaluation kit (EV kit) simplifies the test - Easy Evaluation of the MAX2120 ing and evaluation of the IC direct-conversion tuner. The 50 RF Input SMA Connector evaluation kit is fully assembled and tested at the factory. 50 Baseband Output BNC Connector Standard 50 SMA and BNC connectors are included on the EV kit for the inputs and outputs to allow quick and Single 3.3V 5% Supply easy evaluation on the test bench. 2 I C 2-Wire Serial Interface This document provides a list of equipment required to All Critical Peripheral Components Included evaluate the device, a straightforward test procedure to Fully Assembled and Tested verify functionality, a description of the EV kit circuit, the PC Control Software (available at circuit schematic, a component list for the kit, and artwork www.maximintegrated.com/evkitsoftware) for each layer of the PCB. Ordering Information PART TYPE MAX2120EVKIT+ EV Kit +Denotes lead(Pb)-free and RoHS compliant. Component List DESIGNATION QTY DESCRIPTION DESIGNATION QTY DESCRIPTION Not installed, 3-pin (1 x 3) inline 0.047F 10% ceramic capacitors ADDR 0 header, 0.01in centers C10, C11 2 (0603) Sullins PEC36SAAN Murata GRM188R71C473K BB I O/P, 50 BNC PC mounts 0.033F 10% ceramic capacitor 2 BB Q O/P Amphenol 31-5329-52RFX C15 1 (0603) Murata GRM188R61A334K BB IN, BB IP, 0.022F 10% ceramic capacitor BB QN, BB QP, PC mini red test points C16 1 (0603) CP OUT, 10 Keystone 5000 Murata GRM188R71H223K J12, J13, J17, REF O/P, VGC 10F 10% tantalum capacitors C17, C18 2 (C Case) 1000pF 10% ceramic capacitors AVX TAJC016K016 C1C6, C9, C14 8 (0603) C22 1 43.2 1% resistor (0603)* Murata GRM188R71H102K 330pF 5% ceramic capacitors 0.1F 10% ceramic capacitors C23, C24, C7, C13, C19, 5 (0603) 5 (0603) C71C73 C20, C75 Murata GRM1885C1H331J Murata GRM188R71C104K DB25 right-angle male connector C8, C12, J6 1 0 Not installed, capacitors AMP 5747238-4 C25C29 19-2071 Rev 2 11/14Evaluates: MAX2120 MAX2120 Evaluation Kit Component List (continued) DESIGNATION QTY DESCRIPTION DESIGNATION QTY DESCRIPTION JP VCC, Not installed, SMA edge-mount VCC BB, REF INPUT 0 connector, round contact VCC DIG, Emerson 142-0701-801 Not installed, 2-pin (1 x 2) inline VCC LO, 0 headers, 0.01in centers SMA edge-mount connector, VCC RF1, Sullins PEC36SAAN RF INPUT 1 round contact VCC RF2, Emerson 142-0701-801 VCC SYN, VCC VCO DVBS tuner (28 TQFN-EP**) U1 1 Maxim MAX2120CTI+ 33pF 5% capacitor (0603) L1 1 Murata GRM1885C1H330J Not installed, single-supply op amps U2, U4 0 with R2R outputs R2, R12, Maxim MAX4453ESA R18R20, R22, 0 Not installed, resistors R25, R27R33 74LV07A hex buffer/driver OC U3 1 TI SN74LV07ADR R3, R7, 6 0 5% resistors (0603)* R15R17, R21 Not installed, open I/O comparator U5 0 Maxim MAX985 R4, R5, R13, 4 1k 5% resistors (0603)* R24 4MHz crystal Y1 1 Citizen America 300-8526-1-ND R6 1 820 5% resistor (0603)* Digi-Key HCM49-4.000MABJ-UT R8 1 86.6 1% resistor (0603)* Not installed, shunts (JP VCC, R9R11, R41, 5 100 1% resistors (0603)* VCC BB, VCC DIG, VCC LO, R42 VCC RF1, VCC RF2, VCC SYN, R14, R43 2 5.1k 5% resistors (0603)* 0 VCC VCO) 0.1F 10% ceramic capacitors Shorting jumpers, 2 position R23, R26 2 (0603) Sullins SSC02SYAN Murata GRM188R71C104K 1 PCB: MAX2112/20 EVALUATION KIT R46, R47 2 2.7k 5% resistors (0603)* *Use lead-free parts only. **EP = Exposed pad. Component Suppliers SUPPLIER WEBSITE AMP/Tyco Electronics www.tycoelectronics.com Amphenol RF www.amphenolrf.com AVX Corp. www.avxcorp.com Digi-Key Corp. www.digikey.com Emerson Network Power www.emersonnetworkpower.com Keystone Electronics Corp. www.keyelco.com Murata Americas www.murataamericas.com Sullins Electronics Corp. www.sullinselectronics.com Texas instruments www.ti.com Note: Indicate that you are using the MAX2120 when contacting these component suppliers. Maxim Integrated 2 www.maximintegrated.com