MAX32010EVKIT# Analog Devices

Click here for production status of specific part numbers. MAX32010 Evaluation Kit Evaluates: MAX32010 General Description Features The MAX32010 evaluation kit (EV kit) is a fully Easy Evaluation of the MAX32010 EV kit assembled and tested printed circuit board (PCB) On-Board Voltage Reference (MAX6126) design that evaluates the functionality of device power On-Board DACs for Level Setting supply (DPS) IC MAX32010, which has 25V span output On-Board ADC for Measurements voltage and programmable current ranges up to 1.2A. On-Board Regulators Generate All the Required Voltages from 12V The MAX32010 EV kit contains a microcontroller (MCU) that translates between the SPI interface and USB to USB Interface allow the user to configure internal registers and modes Headers for External SPI and DACs with graphical user interface (GUI) software running on Proven PCB Layout a PC. The EV kit includes Windows 10-compatible Includes Heatsink and Fan software that provides a simple GUI for configuration of Fully Assembled and Tested all the MAX32010 registers through SPI. The EV kit is fully assembled and tested at the factory. This document provides a list of equipment required to evaluate the device, a straightforward test procedure to Ordering Information appears at end of data sheet. verify functionality, a description of the EV kit circuit, component list, circuit schematic, and artwork for each layer of the PCB. The MAX32010 EV kit PCB comes with a MAX32010DCCQ+ installed. EV Kit Top View 319-100642 Rev 0 11/20 MAX32010 Evaluation Kit Evaluates: MAX32010 Quick Start Required Equipment This section lists the recommended test equipment to verify operation of the MAX32010. It is intended as a guide only and substitutions are possible. MAX32010 EV kit Windows PC (Windows 10) with one USB2.0 port Triple Output DC power supply +12V/1.5A -12V/1.5A +5V/500mA Digital voltmeter and ammeter Software and Drivers The MAX32010 EV kit is used in conjunction with the Arm Cortex -M4 processor with FPU MAX32625PICO application platform to control the device through a software application or GUI. Install the MAX32010 EV Kit GUI Software Download the MAX32010 EV kit software from the Maxim Integrated website. See the Appendix section for detailed instructions to install the EV kit software. The installation process takes less than 10 minutes after downloading the software package. Procedure 1) Place the MAX32010 EV kit on a nonconductive surface to ensure that nothing on the PCB gets shorted to the workspace. 2) Set all jumpers in their default position as mentioned in Table 1. 3) Connect the USB cable from PC to EV kit. 4) Apply +12V to VCC, -12V to VEE, and +5V to VDD. 5) Start the MAX32010 EV kit software by opening its icon in the Start Programs menu. The EV kit software main window appears, as shown in Figure 1. 6) In the Max32010 Settings group box, click on the FV radio button in the Measurement Mode group box and click Write button. 7) In the DAC Settings group box, change the voltage for VIN to +1V and click Write button. 8) Check that the output voltage at DUT NODE is close to +1V. Figure 1 shows the MAX32010 EV kit quick start settings. www.maximintegrated.com Maxim Integrated 2