MAX3394E/MAX3395E/ 15kV ESD-Protected, High-Drive Current, MAX3396E Dual-/Quad-/Octal-Level Translators with Speed-Up Circuitry General Description Features 15kV ESD Protection on I/O V Lines The MAX3394E/MAX3395E/MAX3396E bidirectional level CC translators provide level shifting required for data transfer Bidirectional Level Translation Without Direction Pin in a multivoltage system. Internal slew-rate enhancement I/O V and I/O V 10mA Sink-/15mA Source- L CC circuitry features 10mA current-sink and 15mA current- Current Capability source drivers to isolate capacitive loads from lower current Slew-Rate Enhancement Circuitry Supports drivers. In open-drain systems, slew-rate enhancement Larger Capacitive Loads or Larger External Pullup enables fast data rates with larger pullup resistors and Resistors increased bus load capacitance. Externally applied volt- 6Mbps Push-Pull/1Mbps Open-Drain Guaranteed ages, V and V , set the logic-high levels for the device. CC L Data Rate A logic-low signal on one I/O side of the device appears as a logic-low signal on the opposite I/O side, and vice-versa. Wide Supply-Voltage Range: Operation Down to Each I/O line is pulled up to V or V by an internal pullup +1.2V on V and +1.65V on V CC L L CC resistor, allowing the devices to be driven by either push- Low Supply Current in Tri-State Output Mode pull or open-drain drivers. (3A typ) The MAX3394E/MAX3395E/MAX3396E feature a tri- Low Quiescent Current state output mode, thermal-shutdown protection, and Thermal-Shutdown Protection 15kV Human Body Model (HBM) ESD protection on the UCSP, TDFN, and TQFN Packages V side for greater protection in applications that route CC signals externally. Ordering Information The MAX3394E/MAX3395E/MAX3396E accept V volt- CC PART PIN-PACKAGE PKG CODE ages from +1.65V to +5.5V, and V voltages from +1.2V L MAX3394EETA+T 8 TDFN-EP** T833-1 to V , making them ideal for data transfer between low CC MAX3394EEBL+T 9 UCSP B9-5 voltage ASIC/PLDs and higher voltage systems. The MAX3394E/MAX3395E/MAX3396E operate at a guaran- MAX3395EETC+ 12 TQFN-EP** T1244-4 teed data rate of 6Mbps with push-pull drivers and 1Mbps MAX3395EEBC+T 12 UCSP B12-1 with open-drain drivers. MAX3396EEBP+T* 20 UCSP B20-1 The MAX3394E is a dual-level translator available in MAX3396EETP+* 20 TQFN-EP** T2055-4 9-bump UCSP and 8-pin 3mm x 3mm TDFN packages. Note: All devices specified over the -40C to +85C operating The MAX3395E is a quad-level translator available in range. 12-bump UCSP, and 12-pin 4mm x 4mm TQFN packag- +Denotes lead(Pb)-free/RoHS-compliant package. es. The MAX3396E is an octal-level translator available in *Future productcontact factory for availability. 20-bump UCSP and 20-pin 5mm x 5mm TQFN packages. **EP = Exposed paddle. The MAX3394E/MAX3395E/MAX3396E operate over the Selector Guide appears at end of data sheet. extended -40C to +85C temperature range. Pin Configurations Applications TOP VIEW Multivoltage Bidirectional Level Translation (LEADS ON BOTTOM) 2 SPI, MICROWIRE, and I C Level Translation 8 7 6 5 Open-Drain Rise-Time Speed-Up *EP High-Speed Bus Fan-Out Expansion Cell Phones MAX3394E Telecom, Networking, Servers, RAID/SAN + 1 2 3 4 MICROWIRE is a trademark of National Semiconductor Corp. SPI is a trademark of Motorola, Inc. UCSP is a trademark of Maxim Integrated Products, Inc. TDFN *CONNECT EXPOSED PAD TO GROUND Pin Configurations continued at end of data sheet. 19-3884 Rev 3 7/17 V V CC L EN I/O V 1 L I/O V 1 I/O V 2 CC L I/O V 2 GND CCMAX3394E/MAX3395E/ 15kV ESD-Protected, High-Drive Current, MAX3396E Dual-/Quad-/Octal-Level Translators with Speed-Up Circuitry Absolute Maximum Ratings (All voltages referenced to GND.) 12-Pin TQFN (derate 16.9mW/C above +70C) ......1349mW V ..........................................................................-0.3V to +6V 12-Bump UCSP (derate 6.5mW/C above +70C) ......519mW CC V ............................................................................-0.3V to +6V 20-Pin TQFN (derate 20.8mW/C above +70C) ......1667mW L I/O V ......................................................-0.3V to V + 0.3V 20-Bump UCSP (derate 10.0mW/C above +70C) ....800mW CC CC I/O V ........................................................... -0.3V to V + 0.3V Operating Temperature Range ........................... -40C to +85C L L EN............................................................................-0.3V to +6V Storage Temperature Range ............................ -65C to +150C Short-Circuit Duration I/O V , I/O V to GND .....Continuous Junction Temperature ......................................................+150C L CC Maximum Continuous Current..........................................50mA Bump Temperature (soldering) ........................................+235C Continuous Power Dissipation (T = +70C) Lead Temperature (soldering, 10s) .................................+300C A 8-Pin TDFN (derate 18.2mW/C above +70C) ........1455mW 9-Bump UCSP (derate 4.7mW/C above +70C) ........379mW Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Electrical Characteristics (V = +1.65V to +5.5V, V = +1.2V to V C 15pF, C 15pF T = -40C to +85C, unless otherwise noted. Typical CC L CC IOVL IOVCC A values are at T = +25C.) (Note 1) A PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS POWER SUPPLY V Supply Range V 1.2 V V L L CC V Supply Range V 1.65 5.50 V CC CC MAX3394E 150 Supply Current from V I I/O lines internally pulled up MAX3395E 300 A CC CC MAX3396E 600 MAX3394E 30 Supply Current from V I I/O lines internally pulled up MAX3395E 30 A L L MAX3396E 30 V Tri-State Supply Current I EN = GND, T = +25C 3 6 A CC CC-3 A V Tri-State Supply Current I EN = GND, T = +25C 0.7 2 A L L-3 A LOGIC I/O I/O V Input-Voltage High 0.7 x L V V IHL Threshold V L I/O V Input-Voltage Low 0.3 x L V V ILL Threshold V L I/O V Internal Pullup DC L R EN = V or V 5 10 20 k L CC L Resistance I/O V Source Current During L I V = +1.2V 15 mA IHL L Low-to-High Transition I/O V Sink Current During L I V = +1.65V 10 mA ILL CC High-to-Low Transition Maxim Integrated 2 www.maximintegrated.com