MAX77860EVKIT# Analog Devices

Click here for production status of specific part numbers. Evaluates: MAX77860 MAX77860 Evaluation System General Description Features The MAX77860 evaluation system (EV system) is a fully Evaluates MAX77860 Single-Input Switch Mode assembled and tested surface-mount printed circuit board Charger (PCB) that evaluates the single input switched-mode Demonstrates 4.0V to 13.5V Input Operation Range battery charger featuring USB Type-C CC detection and Demonstrates USB Type-C Charging Up to 3.15A charging capability in addition to reverse boost capability Demonstrates Adapter Detection and a safeout LDO. Demonstrates USB-OTG Functionality The MAX77860 EV system includes the integrated circuit 2 (IC) evaluation board with an integrated I C interface and Assembled and Tested a MINIQUSB communication device. Windows based 2 I C Serial Interface graphical user interface (GUI) software is available for use with the EV system and can be downloaded from the MAX77860 product page on the Maxim website. A Windows 7 or newer operating system is required to use the EV kit GUI software. Ordering Information appears at end of data sheet. MAX77860 EV System Files FILE DESCRIPTION MAX77860GUISetupx.x.x.exe Installs EV kit files on PC MAX77860 EV System Component List PART QTY DESCRIPTION MAX77860EVKIT 1 MAX77860 evaluation kit MAXIM MINIQUSB 1 MINIQUSB interface board USB HIGH-SPEED A-TO-B CABLES 6FT 1 MINIQUSB cable Windows is a registered is a registered trademark and service mark of Microsoft Corporation. 319-100317 Rev 2 4/19MAX77860 Evaluation System Evaluates: MAX77860 2) Use the USB cable provided in the EV system to Quick Start connect the MINIQUSB interface board to the PCs Required Equipment USB port. MAX77860 EV kit 3) Install the MAX77860 graphical user interface (GUI) Single-cell Lithium-ion (Li-ion) battery pack from the MAX77860 product page on the Maxim website. Charging wall adapter or DC power supply capable of supplying 15.0V/3A 4) Verify whether the jumper settings follow the default configuration See Jumper Settings section. Standard USB Type A to Type B cable (included in the EV system) 5) Connect a Li-ion battery to the pads labeled BATT and BATTGND. PC running Windows 7 or above 6) Connect a USB wall adapter to the USB Type C port Setup Overview on the board. A typical bench setup for the MAX77860 EV system is 7) Launch the MAX77860 GUI software. shown in Figure 1. 8) Select Device > Connect from the window options Procedure to connect to the EV system. Note: Do not turn on the DC power supplies until all connections are made. 1) Carefully connect the boards by inserting the 20-pin female connector of the MAX77860 EV system with the 20-pin male header of the MINIQUSB interface board. The two boards should be flush with each other. 5V/3A POWER ADAPTER J14 USB TYPE-C INPUT MULTIMETER A BATT MAX77860 EVALUATION BATTERY BOARD BATTGND J2 MINIQUSB BOARD Figure 1. MAX77860 Bench Setup Maxim Integrated 2 www.maximintegrated.com