MAXWSNENV# Analog Devices

Wireless Sensor Node MAXWSNENV Environmental Sensor Demo Kit General Description Benefits and Features The MAXWSNENV demo kit provides a convenient Microcontroller Plus BLE Transceiver Provides a platform evaluating the capabilities of the environmental Convenient Development Platform sensor version of Maxims wireless sensor node (WSN). On-Board Sensors for Temperature, Ambient The kit provides an excellent foundation for the Internet of Light, Humidity, and Barometric Pressure Measure Things (IoT) applications. Environmental Data The WSN board includes a microcontroller, BLE trans- Low-Power Operation Extends Battery Life ceiver, multiple environmental sensors and coin-cell ARM mbed-Compatible HDK Interface Provides holder. The WSN kit also includes a programming adapter Quick Connection to Toolchain compatible with the ARM mbed HDK specification. General-Purpose Pushbutton Switch and Tri-Color Kit Contents LED Allow for Real-Time Input and Feedback MAXWSNENV environmental sensor board with On-Board Battery Holder Provides Convenient and a preprogrammed demo Replaceable Power Source MAXHDK, ARM mbed HDK-compatible hardware development board USB standard A-to-micro-B cable (for connecting MAXHDK to a PC) Coin-cell battery Block Diagram COIN-CELL ANTENNA GPIO TRI-COLOR LED SPI BLE TRANSCEIVER GPIO PUSHBUTTON SWITCH TEMP PRESSURE ANALOG MAX32600 SENSOR SENSOR MMBT3904 BMP180 2 I C LIGHT HUMIDITY SENSOR ANALOG SENSOR RPM-075PT Si7020 19-7633 Rev 0 5/15Wireless Sensor Node MAXWSNENV Environmental Sensor Demo Kit LEDs Detailed Description A single, tri-color LED with series resistors is connected to This demo kit is general purpose in nature, however, the GPIO pins P1.4, P1.6, and P1.7. included sensors allow for the development of sophisti- cated wireless sensor network and IoT nodes. This sec- Component List and Schematic tion describes each major function or component on the MAXWSNENV board. Refer to the following files attached to this data sheet for component information and schematic: Use the MAXWSNENV board with the following separate documents: MAXWNENV BOM.xls MAXWSNENV data sheet (this document) MAXWNENV Schematic.pdf MAX32600 data sheet MAX32600 user guide Ordering Information MAXWSNENV board schematic PART TYPE MAXWSNENV board bill-of-materials MAXWSNENV Demo kit Board Power Denotes RoHS compliant. The demo board is powered by on-board coin-cell battery or by a connected MAXHDK. Bluetooth Low-Energy (BLE) Controller The Bluetooth low-energy controller is Bluetooth V4.0 compliant. Sensors The MAXWSNENV is fitted with four environmental sen- sors. Digital sensors are connected to the MAX32600 I2C master interface. Analog sensors are connected to the MAX32600 ADC interface. The MAXWSNENV includes the following sensors: BMP180 pressure sensor SI7020-A10 humidity sensor RPM-075PTT86 phototransistor NPN diode temperature sensor Pushbuttons Pushbutton SW1 can be used to generate an input for test purposes on port pin P1.5. SW1 is normally open, and therefore, provides a logic 0 when depressed. Firmware defines the action taken on this switch closure. Pushbutton SW2 provides a power-on-reset function to the MAX32600 microcontroller. USB The MAXWSNENV board provides access to the MAX32600 USB D+ and D- signals on connector J1 pins 16 and 18, respectively. Bluetooth is a registered trademark of Bluetooth SIG, Inc. Maxim Integrated 2 www.maximintegrated.com