10-Serie 13000-A_13-Serie 13000-A 31/10/14 09:05 Page44
13000 series
Professional quick-break momentary pushbutton switches
Distinctive features and specifications
UG1410A
PC and panel mount models
Bushing 6,35 (1/4) and 11,9 (15/32)
UL and CECC approved
B2
ELECTRICAL SPECIFICATIONS
Max. current/voltage rating with resistive load :
- silver contacts (A-AD2) : 4A 30VDC
- gold plated contacts (CD) : 100mA 30V
Minimum load (AD2-CD contacts) : 10mA 50mV, 10A 5V min.
Initial contact resistance : 10 m max.
Insulation resistance : 1.000 M min. at 500VDC
Dielectric strength :
1.000 Vrms 50 Hz min. between terminals
2.000 Vrms 50 Hz min. between poles and between terminals and frame
Contact bounce : 2 ms max.
Electrical life :
Contacts Max. current/voltage rating Number of cycles
A 4A 30VDC 50.000
AD2 4A 30VDC 20.000
(gold plating : 100mA 30VDC max.)
CD 100mA 30VDC 50.000
Low level or mechanical life 150.000
MATERIALS GENERAL SPECIFICATIONS
Case : diallylphthalate (DAP) Torque : 1,25 Nm (.922 Ft.lb)
Actuator : brass, nickel plated max. applied to nut
Bushing : brass, nickel plated Standard panel thickness : 2 mm
Housing : brass, nickel plated (.078 ) max.
Contacts : A : silver Total travel : 2 mm (.078)
AD2 : silver, gold plated Operating temperature :
(2 micron gold) -40C to +85C
CD : brass, gold plated
Terminal seal : epoxy
Note : AD2 contacts can be used for high level applications.In this case, the
gold layer is considered only as a protection against oxidation during
storage.
The company reserves the right to change specifications without notice.
B2-44 www.apem.com APEM10-Serie 13000-A_13-Serie 13000-A 04/11/14 14:47 Page45
13000 series
Professional quick-break momentary pushbutton switches
Specifications
RELIABILITY - RUN-IN TEST
Upon request, each individual switch can be submitted to a low level run-in
test of 50 or 250 cycles to ensure suitability for special applications requiring
a very high level of reliability (military, space,etc.).
AGENCY APPROVALS
2A 125VAC/250VAC CECC 96401-001
Designed to MIL specifications
B2
Availability :
UL : all models with silver or gold plated silver contacts
CECC : consult factory for details of approved models.
Marking : to order switches marked UL or CECC, complete appropriate box
of ordering format.
Dimensions : first dimensions are in mm while inches are shown as bracketed numbers.
Sealing boots are available to protect the switches against dust and water. They are presented in section H.
Mounting accessories : standard hardware supplied with all models : 2 hex nuts 8 mm (.314) across flats, 1 locking ring and
1 lockwasher.
Standard and special hardware available are presented in section I.
Packaging unit : 50 pieces.
APEM www.apem.com B2-45