1000 series Compact fingertip controllers switching technology DISTINCTIVE FEATURES One or two axis 5 A 16 A switch solutions Single or double pole Bushing or screw mount Variety of handle options ENVIRONMENTAL SPECIFICATIONS Operating Temperature: -20 C to +50 C (-4 F to + 122 F) Sealing: IP65 (above panel, subject to handle) ELECTRICAL SPECIFICATIONS Maximum Voltage: 250 VAC MECHANICAL SPECIFICATIONS Mechanical Angle of Movement: 24 X & Y axis (subject to limiter plate) Expected Mechanical Life: 5 million lifecycles Mass/weight: 40 g (1.41 oz) (subject to handle) MATERIALS Shaft: Stainless steel Boot: Neoprene Handles : BL - Phenolic D, M, AE - Aluminum F - Nylon H, T, AJ - Stainless steel J, V - ABS Contact : Gold plated silver (switch 1), Silver (other switches ) The company reserves the right to change specifications without notice. 1 JOY-1000-2005 JOYSTICKS1000 series Compact fingertip controllers switching technology MOUNTING V3 SCREW MOUNT CUT-OUT V4 SCREW MOUNT CUT-OUT V4 BUSH MOUNT CUT-OUT V4 SCREW MOUNT CUT-OUT V3 SCREW MOUNT INSTALLATION V4 SCREW MOUNT INSTALLATION V4 BUSH MOUNT INSTALLATION The joystick is mounted from beneath the panel using the 4 x M2.5 machine The joystick is mounted from screws, supplied with the joystick. beneath the panel. Supplied as standard with the joystick is a round bezel which may be fitted Supplied as standard with (according to customer preference) to finish the front face of the panel. all bush mount joysticks, is Fitting the bezel is optional, and is not necessary if the panel cut-out finishes a neoprene sealing gasket. the panel. If fitting the bezel is selected then the panel cut out should be This should be fitted between toleranced such that the bezel is an interference fit. Additionaly bonding the the joystick and the panel, in bezel is recommended. applications where a good seal is needed. Suitable for panel up to 3 mm tick. Torque for fixing nut : < 1 Nm 2 JOYSTICKS