4646A22UU Apem

12-Serie 4400-4600-A 15-Serie 4400-4600-A 30/10/14 15:18 Page82 4600 and 4400 series Toggle switches Distinctive features and specifications UG1410A High current/voltage rating in a small case Butt action contacts Insulated or metal lever A UL, CSA and VDE (EN 61058-1) approved ELECTRICAL SPECIFICATIONS Max. current/voltage rating with resistive load (silver contacts A) : 4A 250VAC - 6A 125VAC Approved electrical ratings : see table below Initial contact resistance : 10 m max. Insulation resistance : 1.000 M min. at 500VDC Dielectric strength : 2.000 Vrms 50 Hz min. between terminals 2.500 Vrms 50 Hz min. between poles and between terminals and frame Electrical life : 10.000 cycles at full load APPROVALS MODELS POLES FUNCTIONS APPROVED RATINGS UL/CSA 4600A 1-2 1-6-9 3A 250VAC - 6A 125VAC 4400A 1-2 1-6 4(2)A 250VAC VDE (EN 61058-1) 4600A 1-2-3 1-6 4(2)A 250VAC MATERIALS GENERAL SPECIFICATIONS Case : melamine phenolic Torque : 0,95 Nm (.70 Ft.lb) max. applied to nut Actuator : Panel thickness : 5 mm (.196) between 2 nuts - insulated : polyamide ,6-6 Operating temperature : -20C to +55C - non-insulated : brass, nickel Hand soldering : 270C max. for 10 seconds max. - iron 3 (.118) plated Bushing : AGENCY APPROVALS - insulated : polyamide 6-6 - non-insulated : brass, nickel plated Contacts : silver EN 61058-1 Availability : see above chart. Marking : VDE approved models are standard marked. To order switches marked UL-CSA, complete appropriate box of ordering format. The company reserves the right to change specifications without notice. A-82 www.apem.com APEM12-Serie 4400-4600-A 15-Serie 4400-4600-A 30/10/14 15:18 Page83 4600 and 4400 series Toggle switches Overview 4 SERIES Terminals Number of poles Electrical functions A 4 Straight PC 3 Single pole 1 ON - OFF 6 Solder lug and quick- 4 Double pole 6 ON - ON connect 5 Three pole 9 ON OFF ON 6../8 Quick-connect 4,7 x 0,8 mm Contact materials Actuators Actuator colours Approvals A Silver UL 1 and 2 pole models 1 Blue CSA -2 Insulated flat lever 2 Black (std) VDE (EN 61058-1) Standard 3 Green 4 Grey 3 pole models 5 Yellow Blank Round metal lever 6 Red -32 Insulated round 7/1 White lever, black 9 Orange For SP and DP models only. ABOUT THIS SERIES Dimensions : first dimensions are in mm while inches are shown as bracketed numbers. NOTICE : please note that not all combinations of above numbers are available. Refer to the following pages for further information. Sealing boots are available on 3 pole models to protect the switches against dust and water. They are presented in section H. Mounting accessories : standard hardware supplied with all models : 1hex nut U166 and 1 knurled nut U520 in the same colour as the lever (insulated models) or U411 nickel plated (metal lever models). Standard and special hardware available are presented in section I. Packaging unit : 20 pieces. APEM www.apem.com A-83