9SA10SQ6500 Apem

9000 series Proportional fingertip controllers inductive sensing technology DISTINCTIVE FEATURES Propotional analog output One or two axis Infinite resolution Low profile design with multiple handle options ENVIRONMENTAL SPECIFICATIONS Operating Temperature: -20 C to +55 C (-4 F to +131 F) Storage Temperature: -20 C to +55 C (-4 F to +131 F) Sealing: IP65 Above panel (subject to final specifications) EMC Immunity Level: EN61000-4-3 EMC Emissions Level: EN61000-6-3: 2001 ESD: EN61000-4-2 ELECTRICAL SPECIFICATIONS Supply Voltage: 4.75V min to 15 V max Output Signal Tolerance: 10% of Output Supply Current: Typically 10 mA Output Impedance: 1.8 Signal Swing: 10% of VCC to 50% of VCC Output at Center: 1% MECHANICAL SPECIFICATIONS Mechanical Angle of Movement: 18 Mechanical Life: 10 million lifecycles Mass/weight: 90 g (0.20 lbs) MATERIALS Body: Glass Reinforced ABS Boot: Neoprene Shaft: Stainless Steel Other: Brass, Acetal, Nylon The company reserves the right to change specifications without notice. 1 JST-9000-2009 JOYSTICKS9000 series Proportional fingertip controllers inductive sensing technology MOUNTING DROP IN - PANEL CUT OUT AND INSTALLATION 3 .2 0 x 4 (0.13) The joystick is dropped into the panel cut-out. The joystick and boot must be kept in place 41. 00 by bezel (option 6 & 7). (1.61) For panel thickness of <3 mm, m3 x 35 .8 0 (1.41) 16 countersunk machine screws are recommended. To ensure a good panel seal, gaskets are available as an optional extra. 35 .8 0 (1.41) OPTION A - PANEL CUT OUT AND INSTALLATION 3 .2 0 x 4 (0.13 x 4) When mounted this way the panel acts as the bezel and no separate bezel is needed. 3 5. 00 (1.38) M3 machine screws are recommended. 35 .8 0 (1.41) 35 .8 0 (1.41 ) OPTION B - PANEL CUT OUT AND INSTALLATION 3 .2 0 x 4 (0.13 x 4) The joystick flange is mounted beneath the panel and the base of the boot must be 3 4. 00 brought through the panel cut-out and held in (1.34) place with the circular bezel (option 4). 35 .8 0 (1.41) For panel thicknesses of up to 3 mm, m3 x 16 countersunk machine screws are recommended. 35 .8 0 (1.41 ) NEAR EQUIVALENT CIRCUIT +V e Supply Y Axis Out put 0V S upply Center Tap Reference X Axis Out put x 2 Pushbutton Dual Decode 2 JOYSTICKS