TH series Proportional single axis throttle controllers non-contacting Hall effect technology DISTINCTIVE FEATURES Friction hold Single or redundant outputs ENVIRONMENTAL SPECIFICATIONS Operating Temperature: -25 C to +70 C (-13 F to +158 F) Storage Temperature: -40 C to +70 C (-40 F to +158 F) Above Panel Sealing: Up to IP63 (subject to handle configuration) EMC Immunity Level: EN61000-4-3: 2006 EMC Emissions Level: EN61000-4-8: 2009 ESD: EN61000-4-2: 2008 ELECTRICAL SPECIFICATIONS Supply Voltage range: 5.00 VDC 0.01 VDC Reverse Polarity Max: -14.5 VDC Ratiometric Output Voltage: See options Transient Overvoltage max: 18 V Output Impedance: 6 Return to Center Voltage Tolerance: 200 mV initial Current Consumption Max: 10 mA MECHANICAL SPECIFICATIONS Operating Force: 7.7 N (1.70 lbf) Break Out Force: 6.6 N (1.50 lbf) Mechanical Angle of Movement: 70 Expected Life: 10 million lifecycles Mass /weight: Varies Lever Action (centering): Friction The company reserves the right to change specifications without notice. 1 JST-TH-2111 JOYSTICKSTH series Single axis throttle controllers non-contacting Hall effect technology REAR MOUNT MATERIALS CUT-OUT DIMENSIONS Body: Glass Filled Nylon 70.48 Handles: Glass Filled Nylon (2.77) 5.50 (0.218 ) ELECTRICAL MICROSWITCH 39.68 Electrical rating: 0.1A at 30VDC (resistive load) (1.56) Insulation resistance: 100 M min (at 500VDC) Contact resistance: 100 M max Dielectric strength: 600VAC, 50/60 Hz for 1 min between 54.0 0 terminals of the same polarity 1,000VAC, 50/60 Hz for 1 (2.125 ) min between current-carrying metal parts and ground and between each terminal and non current-carrying metal parts Vibration resistance: Malfuction 10 to 55Hz, 1.5mm double amplitude CAN J1939 INTERFACE Stock resistance: Destruction 1,000 m/s2 (approx.100G) max SPECIFICATION Malfunction 200 m/s2 (approx. 20G) max Durability: Mechanical 1,000,000 operations min. (60 The TH Series utilizes redundant Hall effect sen- sors to measure the primary X and Y axis. The CAN operations/min) controller support various button configurations as Electrical 100,000 operations min. (30 operations/min) well as proportional thumbwheels and mini-joysticks for additional axis data. All axis and button data are delivered on a CAN 2.0B compliant physical interface. Two additional signals DROP-IN MOUNTING allow configuration of the controller Source Address. CUT-OUT DIMENSIONS Controller messages are delivered per the SAE J1939-71 message protocol. 82.90 (3.265) CAN 2.0B INTERFACE PARAMETERS Baud rate: 250 KHz Transmission repetition rate: 50ms BJMl/EJMl interval time: 20ms 57.50 63.50 (2.265) (2.50) Terminating resistor: No (available by special request to factory) Connection to Deutsch DTM04-6P connector: Pin Color Function 5.16 x 4 R 5.5 4 (0.203 ) 1 White CAN Lo (0.218) 85.70 (3.375 ) 2 Green CAN Hi 3 Blue Source Address SEL 1 4 Orange Source Address SEL 0 5 Black Ground 6 Red 6 - 35 VDC * Operating force: configuration option L 2 JOYSTICKS