WFE 2X remote control Operating InstructionEnglish 1. Introduction by pressing push button (2). Possible steps are 500, 1000, The remote control is a communication tool to read informa- 1500, 2000, 2500 and 3000 hours. When the time get to 0 tion and for settings in the filter system micro processor con- hours the filter alarm goes off. The filter should then be chan- troller. The information will be stored in the micro processor ged (see Operating Instructions for the unit). inside the filter unit and not in the remote control. Hours Application example: 1 Push button - Start/stop 500 Heavy smoke formation, gluing 2 Push button - Filter monitoring 1500 Inspection, re-work 3 Push button - Decrease 2000 Heavy smoke formation if pre filter is used 4 Push button - Increase 5 Indicator - Suction capacity/Power on-off The running time can be resetted by switching on the filter 6 Indicator - Remaining life time unit and at the same time pressing push button (3) and (4) for 7 Indicator - Alarm more than five seconds. 8 Interval selector - Filter exchange 9 Software version - Filter unit 5. Alarm status On the display the alarm status (7) will be blank if the system is running without problems. If the alarm goes off the display will show FILTER ALARM at the same time as a beeping sound is heard. To reset the alarm press push button (4) for 5 more than two seconds. The alarm will then be turned off. 6 6. Check the total time that a filter 7 unit has been running The total time that a unit has been running can be checked 8 by switching on the filter unit and at the same time pressing push button (2),(3) and (4) for more than five seconds. The 9 display will show the software version of the remote control and the total running time of the filter unit. This time can not be resetted. 1 2 3 4 7. Stand-by mode When delivered, the display is set to stand-by mode. The NOTE The push buttons on the remote control has the same display goes down within 30 seconds. To cancel the stand- function as push buttons on the by mode press button (1) and (2) for five seconds. Auto filter unit. Power Down - YES is now shown in the display. Press but- ton (4) once and Auto Power Up - NO is shown. The dispay will automatically go into operation mode. 2. Start the filter unit Start the filter unit with the on/off button on the unit. Press 8. Technical data push button (1) on the remote control. The power indicator Height 110 mm ( 4,3 inch) (5) in the LCD screen will be changed from Power Off to show Width 65 mm ( 2,6 inch) Power and current speed in %. To stop the filter unit press Depth 30 mm ( 1,2 inch) push button (1). The filter unit is now operated via the remo- Weight 0,3 kg ( 0,7 lb) te control and do not need to be switched off on the unit. Battery (only 700-3058)9V 6LR61 Operating time battery 15 h 3. Change the speed of the filter unit When delivered the filter unit will run on maximum speed. To 9. Article number decrease the capacity of the fan press push button (3). The Remote control with cable (standard) 700-3057 power indicator (5) will then change to the new speed. To Remote control (battery) IR 700-3058 increase the capacity again press push button (4). 10. Warranty 4. Change the running time Claims by the buyer for physical defects are time-barred The running time (6) indicates the remaining time before fil- after a period of one year from delivery to the buyer. This ter exchange. The filter unit is set at 1500 hours when deli- does not apply to claims by the buyer for indemnification in vered and will count downwards. This time can be changed accordance with 478, 479 BGB (German Federal Law 1