www.fastertechnology.com FM-S14 Quad SFP/SFP+ transceiver FMC Quad fiber-optic and/or copper interfaces for Gigabit Ethernet and other high- speed serial protocols Features Industry standard, modular FPGA I/O in FMC (VITA 57) module High-speed serial, fiber optic or copper, connec- tions into an FPGAs MGT interfaces One quad-SFP cage supports four (4) SFP/ SFP+ transceiver modules Fully FMC compatible Supports a wide range of SFP and SFP+ trans- ceivers with signaling rates up to 10Gb/sec 2.5 or 1.8 volt signaling (Rev C or newer) The FM-S14 is electrically compliant with the FMC Two programmable reference clocks standard. Due to the size of the quad SFP cage, the FM-S14 is classified as a mechanical superset of Benefits the FMC mechanical standards. Special attention should be paid to ensure that the FM-S14 is me- Direct connections between SFP/SFP+ trans- chanically compatible if used with non-supported ceivers and host FPGA ensures maximum host carrier cards. throughput and minimum latency Easily interfaces high-density, high-speed I/O to SFP Transceivers an FPGA-based host board 2.5V or 1.8 volt signaling ensures compatibility The FM-S14 imposes no restrictions on SFP/SFP+ with Virtex-6, Kintex-7, Virtex-7 and other transceivers any SFP/SFP+ transceiver that com- FPGAs plies with the SFP and SFP+ Multi-Source Agree- ments (MSAs) can be mounted on the FM-S14. Overview However, the FPGA host board on which the FM- S14 is mounted may impose restrictions on the The FM-S14 is an FPGA Mezzanine Card (FMC) SFP/SFP+ transceivers and clock frequencies. SFP module that provides up to four SFP/SFP+ module transceivers must be ordered separately or from interfaces directly into Multi-Gigabit Transceivers third party suppliers. (MGTs) of a Xilinx FPGA. Note: In various Xilinx FPGA families, Xilinx refers to these high-speed se- Clocks rial links as RocketIO ports, GTHs, GTXs, and GTPs. For simplicity, in this product brief they will The FM-S14 provides two reference clocks that are collectively be referred to as MGTs. The FM-S14 available as inputs to the FPGA on the baseboard. supports the industry standard Small Form-factor The clocks provide programmable frequencies from Pluggable (SFP/SFP+) transceiver module inter- 15.48 to 1300 MHz. One of the four default frequen- face. cies can be selected using switches on the FMC The FM-S14 supports either 1.8 or 2.5 volt signaling module. Other frequencies are programmable from 2 to ensure interoperability across a wide range of the host boards FPGA via an I C interface to the Spartan, Virtex, Kintex, Artix and other FPGA fami- FMC module. lies. Faster Technology LLC 1812 Avenue D, Suite 202 Katy, TX 77493 T: 281.391.5482 F: 281.391.9384 info fastertechnology.com www.fastertechnology.com FM-S14 Quad SFP/SFP+ transceiver FMC FM-S14 Technical Specifications Supported Media Fiber Optic SFP/SFP+ Transceivers - One (1) to four (4) pluggable SFP or SFP+ transceivers Copper SFP Transceivers - One (1) to four (4) pluggable SFP transceivers FPGA Interface FMC High Pin Count (HPC) connector Four (4) high-speed serial FMC links DP0 DP3 dual differential pairs 2 I C reference clock control LA00 LA01 Default frequency select switches LA02 LA03 SFP control signals (7 each) LA04 LA17 General purpose LEDs LA18 LA19 Reference clocks (2) GBTCLK0-M2C & GBTCLK1-M2C Default frequencies of 212.5, 250, 300, 312.5 MHz. Supported Host boards Spartan-6 Xilinx EK-S6-SP605 Virtex-6 Xilinx EK-V6-ML605 Kintex-7 Xilinx EK-K7-KC705 Virtex-7 Xilinx EK-V7-VC707 On-board serial EEPROM 256 Byte Serial PROM 2 EEPROM interface I C via FMC SCL / SDA interface 2 I C address via FMC GA0 / GA1 Miscellaneous FMC compliance ANSI/VITA 57.1-2008 compatible Block Diagram Related Products SFP 0 RX SFP SFP 0 Control Level Shift Connector SFP 0 TX FM-S18 FMC compatible module with two quad SFP 1 RX SFP/SFP+ cages supporting up to eight SFP SFP 1 Control X4 Level Shift Connector SFP 1 TX (8) SFP or SFP+ Modules SFP SFP 2 RX SFP SFP 2 Control Level Shift Cage Connector SFP 2 TX FM-S28 FMC compatible module with two QSFP/ SFP 3 RX SFP 3 Control SFP QSFP+ cages supporting up to two (2) Level Shift Connector SFP 3 TX QSFP or QSFP+ Modules for up to 40 Gigabits per second per QSFP+ 2 I C Clock Clock EEPROM Switches Generator Generator 2 I C Ordering Information 2 I C FM-S14 FMC compliant module with one quad SFP/SFP+ cage to support up to four (4) SFP or SFP+ Modules Faster Technology LLC 1812 Avenue D, Suite 202 Katy, TX 77493 T: 281.391.5482 F: 281.391.9384 info fastertechnology.com HPC Connector