IQS680EV02-S Azoteq

IQ Switch ProxFusion Series IQS680EV02 Overview Combination sensor with dual channel capacitive proximity/touch, Passive Infrared Radial sensor and metal detection capabilities The IQS680 ProxFusion IC is a multifunctional Capacitance, Passive Infrared Radial (PIR) & Inductance sensor designed for applications such as domestic energy efficient lighting applications with movement detection. The IQS680 is an ultra-low power solution designed for short or long-term activations through any of the sensing channels. The 2 IQS680 operates standalone or via the I C protocol and custom configurations are stored in an on-chip EEPROM. EV-Kit Overview PIR sensing (Movement sensing) Capacitive sensing Inductive sensing (Requires writing to the EEPROM) Sample coil/touch pad supplied Evaluation Modes Standalone Mode (Default) Figure 1: IQS680EV02 Orthogonal view o Events shown by LEDs 1 Connect IQS680EV02 via a CT210A USB Dongle to PC GUI o Raw information displayed in GUI Assemble the module into a mock-up application and test o Sample inductive coil/touch pad supplied Connect custom coil or touch pad to sensor board Figure 2: IQS680EV02 Top view Figure 3: IQS680EV02 Bottom view Applications Movement detection Under Cabinet Lighting White goods and appliances Standard PIR sensor cost reduction Human Interface Devices Battery powered PIR sensors solutions Movement activated backlighting Smart Lights Night Lights 1 Sold Separately Copyright Azoteq 2018 IQS680EV02 Overview v1.3 Page 1 of 3 All Rights Reserved IQS680 Datasheet April 2018 IQ Switch ProxFusion Series Quick Start (Default Settings) Ensure that two 3V coin-cell batteries are inserted in the battery holder (6V). Place a lens over the PIR sensor and switch S1 to standalone and S2 to PIR mode. Wait for both LEDs to go off (PIR is stabilizing). A movement will trigger the PIR sensor. A PIR event is indicated by the red LED and the blue LED has a predefined timeout. A capacitive touch on the coil will switch the light on/off and a long press will change the brightness of the blue LED. Get the latest software at