Product Line Specifications MULTI-BEAM Sensors Compact modular self-contained photoelectric sensing controls Status Indicator LED (except emitters) Access to Sensitivity Adjustment 1.6 (40 mm) 2.1 (53 mm) Lens Centerline 4.5 (114 mm) 3.7 (94 mm) 2.36 (60.0 mm) 0.30 (7.6 mm) 0.20 1/2 14 NPSM (5.1 mm) Conduit Entrance 5 mm ( 10) Screw 1.18 Clearance (4) (30.0 mm) Modular design with interchangeable components (scanner blocks, power blocks, and logic timing modules) over 5,000 sensor configurations possible Scanner blocks for opposed, retro, diffuse, convergent, and fiber optic sensing modes (including high-gain models) Power blocks for ac or dc operation, including 2-wire ac operation Logic modules to support a wide variety of delay, pulse, limit, and rate sensing logic functions Most scanner blocks include Banner s exclusive, patented AID (Alignment Indicating Device) system, which lights a top-mounted indicator LED whenever the sensor sees its own modulated light source, and pulses the LED at a rate proportional to the strength of the received light signal. Printed in USA P/N 32887 Contents Introduction to MULTI-BEAM Modular Sensors ........................... page 3 Selection of components and summary of available models ............ pages 4-6 MULTI-BEAM 3- and 4-wire Sensors............................................ pages 6-23 3- and 4-wire Scanner Blocks ................................................. pages 6-14 3- and 4-wire Scanner Block modifications ........................... page 14 3- and 4-wire Power Blocks ................................................... pages 15-20 3- and 4-wire Logic Modules ................................................. pages 21-23 MULTI-BEAM 2-wire Sensors....................................................... pages 24-29 2-wire Scanner Blocks ............................................................ pages 24-26 2-wire Power Blocks .............................................................. pages 27-28 2-wire Logic Modules ............................................................ page 29 MULTI-BEAM Accessories............................................................ pages 30-31 Upper Covers (lens assemblies).............................................. page 30 Lower Covers ......................................................................... page 30 Mounting Brackets ................................................................. page 31 Quick Disconnect ................................................................... page 31 WARNING MULTI-BEAM photoelectric presence sensors described in this catalog do NOT include the self- checking redundant circuitry necessary to allow their use in personnel safety applications. A sensor failure or malfunction can result in either an energized or a de-energized sensor output condition. Never use these products as sensing devices for personnel protection. Their use as a safety device may create an unsafe condition which could lead to serious injury or death. Only MACHINE-GUARD and PERIMETER-GUARD Systems, and other systems so designated, are designed to meet OSHA and ANSI machine safety standards for point-of-operation guarding devices. No other Banner sensors or controls are designed to meet these standards, and they must NOT be used as sensing devices for personnel protection. WARRANTY: Banner Engineering Corporation warrants its products to be free from defects for one year. Banner Engineering Corporation will repair or replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied. Banner Engineering Corp. 9714 Tenth Ave. No. Minneapolis, MN 55441 Telephone: (612)544-3164 FAX (applications): (612)544-3573