A BELDEN BRAND Diamond Drop Hardware Drop Wire Clamps for CATV and Telephone Cable Universal Messenger Cable Drop Wire Clamp Permits cable to float free, fully protected from strain and chafing. Drop clamp for the suspension of a messengered drop cable between the pole, midspan and house. For use with RG59, RG6 and other cables Stainless steel bail wire and aluminum body. Inner Outer Part Number Description Pack Pack SC02MFA-SS Universal Messenger Drop Wire Clamp -- 125 Installation: 1. Begin separation of the messenger wire from the cable using the end-edge of the SC02MFA-SS Drop 1 Clamp. Note: Never use a knife or other sharp tool to separate messenger and cable. 2 2. Fit the cable and messenger wire into the SCO2MFA- SS Drop Clamp as shown, so that the Clamp Bail is between the two. 3. Grasp the separated end of the messenger and cable with one hand and grip the Clamp Body, as shown, 3 with your other hand. Then, pull the SC02MFA-SS back, in a straight line, separating the length of messenger wire needed to make the wrap about 15 to 18-inches. 4 4. Pull the messenger wire around the center of the bearing surface as shown, toward the rear or drop- side of the Clamp. Note: If at the house end of the drop, this will be done while tensioning or sagging the drop. 5 5. Pass the messenger wire through the L Slots and begin the wrap about the SC02MFA-SS body, as shown. 6. Continue the messenger wire wrap for two full turns. 7. Pass the messenger wire through the L Slot, as 6 shown, to the drop-side of the SC02MFA-SS and cut the excess wire away, or ground it to the strand. Note: For drop cable with larger messenger wire, one wrap is sufficient. Wrap the end of the wire around the end of the SC02MFA-SS and bring it back up the 7 L Slots, then cut away the excess, or ground it to the strand. www.ppc-online.com Customer Support: 800.800.6652 6 A BELDEN BRANDDrop Hardware Diamond Drop Hardware Drop Wire Clamps for CATV and Telephone Cable Drop Wire Clamp Used to support both ends of telephone drop, at strand and building. Suitable for 1-2 pair .200 max. height and .410 max. width. 6 pair version: .300 max. height and .500 max. width. Stainless steel bailwire on all versions. Special Packages available. Please check with your PPC/Belden Representative. Shim Inner Outer Part Number Description Material Pair Type Pack Pack 23-44441 Drop Wire Clamp Aluminum 1-2 Serrated -- 500 Drop Wire Clamp 23-44444 Aluminum 1-2 Serrated 25 500 (Bell Packaging) 23-44445 Drop Wire Clamp Aluminum 1-2 Serrated 2 250 23-82350 Drop Wire Clamp Aluminum 6 Dimpled 1 75 23-82351 Drop Wire Clamp Aluminum 6 Dimpled 25 150 Drop Wire Clamp Stainless 23-88881 1-2 Serrated 25 500 (Bulk Packaging) Steel Stainless 23-88885 Drop Wire Clamp 1-2 Serrated 2 250 Steel Installation: 1. Lay cable in shell. 2. Place shim on top of cable with raised embossings against cable. 3. Insert wedge in shell (on top of shim) and pull to engage. (Small end of wedge should be initially engaged in track of large end of shell). 4. Place bailwire on B drop wire hook (rams horn)with wedge loose. Pull drop wire through clamp until proper sidewalk/alley clearance is achieved. 5. Grasp clamp (bailwire still on rams horn) and pull tightly to secure. Customer Support: 800.800.6652 www.ppc-online.com 7 A BELDEN BRAND