EK1601-7R Bel Fuse

K Series with PFC Data Sheet 150 280 Watt AC-DC Converters Features RoHS lead-free-solder and lead-solder-exempted pro- ducts are available 5 year warranty for RoHS compliant products with an extended temperature range Class I equipment Power factor >0.93, harmonics IEC/EN 61000-3-2 Immunity according to IEC/EN 61000-4-2, -3, -4, -5, -6, -8, -9 Compliant with EN 50155, EN 50121-4, EN 45545 (version V108 or later). High efficiency Input over- and undervoltage lockout Adjustable output voltage with remote on/off 1 or 2 outputs: SELV, no load, overload, and short-circuit proof Rectangular current limiting characteristic PCBs protected by lacquer Very high reliability 111 4.4 3 U Safety-approved to the latest edition of IEC/EN 60950-1 and UL/CSA 60950-1 80 168 3.2 6.6 16 TE inhibited by a logic signal applied to connector pin 18. If the Description inhibit function is not used, pin 18 must be connected with pin The LK4000/5000 Series of AC-DC converters represents a 14 to enable the outputs. flexible range of power supplies for use in advanced LED indicators display the status of the converter and allow electronic systems the LKP models are an extension with visual monitoring of the system at any time. increased output power, but optimized to 230 VAC. Features include full power factor correction, good hold-up time, high Full input to output, input to case, output to case and output to efficiency and reliability, low output noise, and excellent output isolation is provided. The converters are designed and dynamic response to load/line changes. built according to the international safety standards IEC/EN nd 60950-1 2 Ed. They have been approved by safety The converters are protected against surges and transients agencies. occurring at the source lines. Input over- and undervoltage lockout circuitry disables the outputs, when the input voltage The case design allows operation at nominal load up to 71 C is outside of the specified range. Input inrush current in a free air ambient temperature. If forced cooling is provided, limitation is included for preventing circuit breakers and fuses the ambient temperature may exceed 71 C, but the case from tripping at switch-on. temperature must remain below 95 C under all conditions. However, higher output power up to 280 W is possible All outputs are overload, open- and short-circuit proof, and depending on environmental conditions and converter model. protected by a built-in suppressor diode. The outputs can be Table of Contents Page Page Description ....................................................................... 1 Electromagnetic Compatibility (EMC) ........................... 16 Model Selection ............................................................... 2 Environmental Conditions ............................................. 17 Functional Description..................................................... 4 Mechanical Data ............................................................ 18 Safety and Installation Instructions ............................... 20 Electrical Input Data ........................................................ 5 Description of Options ................................................... 22 Electrical Output Data ..................................................... 8 Auxiliary Functions ........................................................ 13 Accessories ................................................................... 27 Copyright 201 8, Bel Power Solutions Inc. All rights reserved. MELCHER BCD20001-G Rev AF1, 17-Apr-2018 Page 1 of 28 The Power Partners.K Series with PFC Data Sheet 150 280 Watt AC-DC Converters An internal temperature sensor generates an inhibit signal, according to IEC 60297-3, or be mounted on a chassis or which disables the outputs, when the case temperature T plate. C exceeds the limit. The outputs automatically recover, when Important: the temperature drops below the limit. These products are intended to replace the LK1000 and LK2000 Various options are available to adapt the converters to models, in order to comply with IEC/EN 61000-3-2. For appli- cations with DC input or main frequencies other than 50/60 Hz, the individual applications. An external temperature sensor is LK1000 and LK2000 model types are still available. available to allow for temperature adapted battery charging. The converters may either be plugged into 19 rack systems Model Selection Non-standard input/output configurations or special customer adaptations are available on request. Table 1: Standard models 1 Output 1 Output 2 Operating input range Type designation Efficiency Options V I V I V V o nom o nom o nom o nom i min i max min VDC A VAC A VAC % 2 4 5.1 20 85 264 LK4002-9ERG 79 -7, -7E, P, D , T, K , B, B1, non-G 2 4 5.1 25 LK4003-6ERG 79 P, D , T, K , B, B1, non-G 2 12 12 85 264 LK4301-9ERG 84 -7, -7E, P, D , T, B, B1, non-G 2 15 10 LK4501-9ERG 85 -7, -7E, P, D , T, B, B1, non-G 2 24 6 LK4601-9ERG 86 -7, -7E, P, D , T, B, B1, non-G 3 2 12 6 12 6 85 264 LK5320-9ERG 83* -7, -7E, P, D , T, B, B1, non-G 3 2 15 5 15 5 LK5540-9ERG 83 -7, -7E, P, D , T, B, B1, non-G 3 2 24 3 24 3 LK5660-9ERG 84* -7, -7E, P, D , T, B, B1, non-G 3 2 12 10 12 10 187 255 LKP5320-6ERG 85 -6, P, D , T, B, B1, non-G 3 2 24 5.2 24 5.2 LKP5660-9ERG 87* -7, -7E, P, D , T, B, B1, non-G 3 2 24 5.8 24 5.8 LKP5661-5ERG 87* P, D , T, B, B1, non-G * Valid for actual models with version V 107 or later. 1 Min. efficiency at V , I and T = 25 C. Typical values are approximately 2% better. i nom o nom A 2 Different options D (D0 DD). 3 Second output semi-regulated 5 For new designs, use only option K. Table 2: Battery charger models 4 1 Nom. output values Output range Operating input range Type designation Efficiency Options V I V V V V o nom o nom o min o max i min i max min VDC A VDC VAC % 2 12.84 10 12.62 14.12 85 264 LK4740-9ER 84 -7, -7E, D , T, B, B1, non-G 2 2 25.68 5.4 25.25 28.25 LK5740-9ER 84* -7, -7E, D , T, B, B1, non-G 3 2 51.36 2.7 25.5 56.5 LK5740-9ER 84* -7, -7E, D , T, B, B1, non-G 2 2 25.68 9 25.25 28.25 187 255 LKP5740-9ER 87* -7, -7E, D , T, B, B1, non-G 2 2 25.68 10 25.25 28.25 LKP5741-5ER 87* D , T, B, B1, non-G 3 2 51.36 4.5 50.5 56.5 187 255 LKP5740-9ER 87* -7, -7E, D , T, B, B1, non-G 3 2 51.36 5 50.5 56.5 LKP5741-5ER 87* D , T, B, B1, non-G * Valid for actual models with version V 107 or later. 1 Min. efficiency at V , I and T = 25 C. Typical values are approximately 2% better. i nom o nom A 2 Both outputs connected in parallel 3 Both outputs connected in series 4 Controlled by the battery temperature sensor see Accessories NFND: Not for new designs Preferred for new designs MELCHER BCD20001-G Rev AF1, 17-Apr-2018 Page 2 of 28 The Power Partners.