The SLAN-03D2A modules are non-isolated DC-DC converters that can deliver up to 3 A of output current. These modules operate over a wide range of input voltage (Vin = 3 -14.4 VDC) and provide a precisely regulated output voltage from 0.6 VDC to 5.5 VDC, programmable via an external resistor. Features include remote on/off, adjustable output voltage, over current and over temperature protection. The tunable loop feature allows the user to optimize the dynamic response of the converter to match the load with reduced amount of output capacitance leading to savings on cost and PWB area. Non-Isolated Power Good signal Remote On/Off Over Temperature Protection Cost Efficient Open Frame Design Ability to Sink and Source Current DOSA Based Fixed Switching Frequency Output Voltage Programmable from 0.6 to 5.5 VDC via External Resistor TM Tunable Loop to Optimize Dynamic Output Voltage Response Output Over-Current Protection (non-latching) Small size:12.19 12.19 6.25 mm (0.48 0.48 0.246 inch) Approved to IEC/EN 62368-1 Approved to UL/CSA 62368-1 Class II, Category 2, Isolated DC/DC Converter (refer to IPC-9592B) Distributed Power Architectures Intermediate Bus Voltage Applications Telecommunications Equipment Servers and Storage Applications Networking Equipment Industrial Equipment SLAN-03D2A 2 MODEL OUTPUT INPUT MAX. OUTPUT MAX. OUTPUT TYPICAL NUMBER VOLTAGE VOLTAGE CURRENT POWER EFFICIENCY SLAN-03D2A0G SLAN-03D2A0R 0.6 - 5.5 VDC 3 - 14.4 VDC 3 A 16.5 W 93.9 % SLAN-03D2ALG SLAN-03D2ALR S LAN - 03 D 2A x y Output Input Voltage Sequencing Logic Mounting Type Series Code Package Current Range or not Status 0 Active High G Tray Package Without Surface Mount SLAN Series 3 A 3 - 14.4 VDC Sequencing L Active Low R Tape & Reel Package PARAMETER DESCRIPTION MIN TYP MAX UNITS Continuous Input Voltage -0.3 - 15 V Operating Temperature See Thermal Considerations section -40 - 85 C Storage Temperature -55 - 125 C Altitude - - 4000 m NOTE: Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings only, functional operation of the device is not implied at these or any other conditions in excess of those given in the operations sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect the device reliability. PARAMETER DESCRIPTION MIN TYP MAX UNIT Operating Input Voltage 3 - 14.4 V Input Current (full load) VIN =3 to 14 V, Io = Io max - - 2.4 A VO,set = 0.6 VDC - 17 - VIN = 12 VDC, Io = 0, Input Current (no load) mA module enabled VO,set = 5 VDC - 38 - Input Stand-by Current Vin = 12 V, module disabled - 0.8 - mA 5 Hz to 20 MHz, 1 H source impedance VIN = 0 to 14 V, Input Reflected Ripple Current (pk-pk) - 15 - mA Io = Io max See Test Configurations 2 2 I t Inrush Current Transient - - 1 A s Input Ripple Rejection (120 Hz) - -60 - dB NOTE: Unless otherwise indicated, specifications apply over entire operating input voltage range, resistive load, and temperature conditions. tech.support psbel.com