The SLAN-12D2A modules are non-isolated DC-DC converters that can deliver up to 12 A of output current. These modules operate over a wide range of input voltage (VIN = 3 14.4 VDC) and provide a precisely regulated output voltage from 0.6 to 5.5 VDC, programmable via an external resistor. Features include remote on/off, adjustable output voltage, over current and TM over temperature protection. The Tunable Loop feature allows the user to optimize the dynamic response of the converter to match the load with reduced amount of output capacitance leading to savings on cost and PWB area. Non-Isolated Power Good Signal Remote On/Off Over Temperature Protection Cost Efficient Open Frame Design DOSA Based Fixed Switching Frequency Class II, Category 2, Isolated DC/DC Converter (refer to IPC-9592B) Compliant to RoHS EU Directive 2002/95/EC Compatible in a Pb-free or SnPb Reflow Environment Output Voltage Programmable from 0.6 to 5.5 VDC via External Resistor TM Tunable Loop to Optimize Dynamic Output Voltage Response Output Over-Current Protection (non-latching) Wide Operating Temperature Range -40C to 85C Wide Input Voltage Range (3 - 14.4VDC) Approved to IEC/EN 60950-1 Small size:12.19 12.19 8.5 mm (0.48 0.48 0.335 inch) Cost Efficient Open Frame Design Ability to Sink and Source Current Distributed Power Architectures Servers and Storage Applications Intermediate Bus Voltage Applications Networking Equipment Telecommunications Equipment Industrial Equipment 2 SLAN-12D2A MODEL MODEL OUTPUT INPUT MAX. OUTPUT MAX. OUTPUT TYPICAL NUMBER NUMBER VOLTAGE VOLTAGE CURRENT POWER EFFICIENCY ACTIVE LOW ACTIVE HIGH SLAN-12D2ALR SLAN-12D2A0R 0.6 5.5 VDC 3 14.4 VDC 12 A 66 W 95% SLAN-12D2ALG SLAN-12D2A0G S LAN - 12 D 2A x x Mounting Output Input voltage Sequencing or Logic Series code Package type current range not status 0 Active High G Tray Package Surface Without SLAN series 12 A 3 14.4 V mount Sequencing L Active Low R Tape & Reel Package PARAMETER DESCRIPTION MIN TYP UNITS Continuous Input Voltage -0.3 15 V Operating Ambient Temperature See Thermal Considerations section -40 85 C Storage Temperature -55 125 C Altitude - 2000 m NOTE: Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings only, functional operation of the device is not implied at these or any other conditions in excess of those given in the operations sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect the device reliability. PARAMETER DESCRIPTION MIN TYP MAX UNIT Operating Input Voltage 3 - 14.4 V Input Current (full load) VIN = 3 to 14.4 V, Io= Io max - - 12 A Vo set = 0.6 VDC - 45 - VIN = 12 VDC, Io = 0, Input Current (no load) mA module enabled Vo set = 5 VDC - 75 - Input Stand-by Current VIN = 12 V, module disabled - 0.65 - mA 5 Hz to 20 MHz, 1 H source impedance VIN = Input Reflected Ripple Current (pk-pk) - 40 - mAp-p 0 to 14 V, Io = Io max See Test Configurations 2 2 I t Inrush Current Transient - - 1 A s Input Ripple Rejection (120 Hz) - -60 - dB NOTE: Unless otherwise indicated, specifications apply over entire operating input voltage range, resistive load, and temperature conditions. tech.support psbel.com